0
Add your answer:
Earn +20 pts
Which way to turn the Cone Washer on the water Inlet Line to the Toilet Tank?
The smaller end of the cone goes up into the tank.
Your toilet will not fill up?
check that the toilet stopper has been switched on and check that the strainer inside the toilet inlet is clear of debris
Name of the tank that holds water used to flush toilet?
Toilet tank
What is water head?
Water head is the vertical height of inlet of water supply from the bottom of the storage tank to the inlet of the Cistern.
What is a vacuum breaker in plumbing?
A vacuum breaker is a device that prevents water in a toilet cistern or water tank, from syphoning back into the toilet cistern or water tank.
Does flushing a toilet not use water?
Each flush of a toilet uses the same amount of water.
What container holds toilet water?
A toilet tank, located at the back of the toilet bowl, holds clean water for flushing the toilet.
Where is the toilet washer?
seal to stop water from runing into tank located between tank and bowk
Toilet does not flush?
There are main five reasons for your toilet does not flush. Clogged in the toilet Poor/defective pipe Quality tank water level is low. Damaged flapper Inlet holes blocking These are the most common problems, you can check these one by one and solve your solutions.
What do you do if the bladder to your water tank sagged and is blocking the inlet to the tank?
In this case the only proper thing is to get a new bladder tank.
How do you stop a toilet tank condensation?
Install a tempering valve in water line feeding toilet. Tempering valve will mix hot and cold water together so warm water fills toilet tank which will stop condensation.
How do you replace dip tube on hot water heater?
Take cold inlet water pipe off tank. The dip tube sits below the fitting joining to the tank on the cold inlet side. You can pull it out and replace it.
