It might be clicking because you have something solid in there. It may be a zipper that hits against the walls.
yes
A washing machine typically makes a humming or whirring sound as it fills with water, agitates, spins, and drains during the wash cycle. If the machine is making loud or unusual noises, it may indicate an issue that requires maintenance or repair.
Your washing machine may be loud when it spins due to unbalanced loads, worn out bearings, or a malfunctioning motor. These issues can cause excessive vibrations and noise during the spinning cycle.
Yes, the inner tub of a washing machine spins during the wash and rinse cycles. This spinning motion helps to agitate the clothes, helping to remove dirt and stains more effectively.
In a washing machine, electrical energy is transformed into mechanical energy to run the motor that spins the drum. Additionally, some of the electrical energy is transformed into heat energy to heat the water for washing.
A washing machine washes laundry and usually spins them to a damp state it does not dry clothes. You need to hang them on a line to air dry or use a drying machine.
Mechanical energy is transformed into kinetic energy in a washing machine as it agitates, spins, and pumps water during the washing and rinsing cycles. This kinetic energy is used to clean the clothes and remove dirt and stains.
The washing machine works by filling with water and rotating. The operator has to put in soap, bleach and softener. The washer agitates, then spins, then fills with water, then rinses by agitating, then drains again by spinning.
A washing machine removes water from clothes during the spin cycle. During this cycle, the drum of the washing machine spins rapidly, creating centrifugal force that pushes the water out of the clothes and towards the walls of the drum. The water is then drained out of the machine through a drainage pipe.
Your washing machine is still running but no more spin wash or jerking it only spins still in the middle and it does not squeeze out the water well like before what should you fix it?
It most likely shakes when it spins because when it washes, the load gets greater or heavier on one side. As a result, when it spins centrifugal force causes the heavier load to overcome the weight of the washer, causing it to spin.
don't over load it, or get after market feet with adhesive on them