answersLogoWhite

0

Sounds like you have a "water logged " ptressure tank. Switch pump off and drain water almost to bottom, then check air pressure at top nipple. if it's less than 20 psi or so, that's your problem. Try pumping it at the top with a small compressor. Put 30 psi in then turn on pump and see if it's better. If it's a bladder tank there are possibly pin holes in bladder.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What are the symptoms of a waterlogged pressure tank?

Symptoms of a waterlogged pressure tank include short cycling of the pump, reduced water pressure, and frequent pump motor starting and stopping.


What are common issues that can arise with well pump pressure switch problems?

Common issues that can arise with well pump pressure switch problems include inconsistent water pressure, frequent cycling of the pump, and potential damage to the pump motor.


Why does a well pump keep cycling?

The pressure switch could be faulty, the pressure tank could be waterlogged, the pump intake could be at static water level. Call a well technician.


What are the benefits of using a bladder tank for a well pump system?

Using a bladder tank for a well pump system helps maintain consistent water pressure, reduces pump cycling, extends the lifespan of the pump, and improves overall system efficiency.


Why is your well pump cycling every twenty seconds when in use only?

The pressure tank is full of water and has no air charge.


Why is my well pump cycling frequently when there is no water running?

Your well pump may be cycling frequently when there is no water running due to a potential issue with the pressure tank or pressure switch. This could be caused by a leak in the system, a faulty pressure switch, or a waterlogged pressure tank. It is recommended to have a professional inspect and repair the system to prevent further damage.


What are the benefits of using a bladder tank for well water storage?

A bladder tank for well water storage helps maintain consistent water pressure, reduces pump cycling, prolongs the life of the well pump, and provides a more efficient and reliable water supply system.


How do you tell if you need a water pump?

If the pump is blowing breakes, there is probably a short in the pump. The well could also be ceased. If there is very little water being pumped, the well could be dry or the pump might be "shot" http://www.irrigationsolutions.com


What are the symptoms of a bad pressure tank?

Symptoms of a bad pressure tank include fluctuating water pressure, short cycling of the pump, air sputtering from faucets, and waterlogged tank noises.


How can I determine if my well pump is bad?

To determine if your well pump is bad, you can check for signs such as low water pressure, strange noises coming from the pump, or frequent cycling on and off. You can also test the pump's electrical connections and pressure switch to see if they are functioning properly. If you suspect a problem, it's best to consult a professional for a thorough inspection and repair.


Is it better to let a well pump run continously or to cycle?

Normally cycle BUT not to short cycle


When a well pump comes on and off very quickly is this is a long cycle an intermediate cycle or a short cycle?

It is probably clogged up and overheating so its safety cutout shuts down the power until it cools down enough to switch on again. To fix it, it will have to be disconnected and taken out of the well so that the pump chamber, the impeller and all associated pipes can be cleaned. This needs to be done regularly, depending on the condition of the water. If the pump was working a fountain in an outside pond a good time to clean it would be when it is taken out of the pond for the winter. If your weather is warm enough to leave the pump in the pond all year round it should still be taken out and cleaned regularly.