Possibly because there is a partial blockage down the pipe the waser connects too,and some other waste water finds it easier to come up the washer pipe.
It saves waste water backing up to or from the washing machine.
no never submerge light up shoes in water. the best way to wash them is with a cloth/rag and soapy water.
The washing machine's temperature control was broken, so the water did not heat up. so we could not wash our cloths
scanstate which is the machine that you are backing up from. and loadstate which is the machine that you are restoring from.
The recommended washing machine drain height for optimal performance and efficiency is typically around 30 inches above the floor level. This height helps to prevent water from backing up and ensures proper drainage during the wash cycle.
You would need a pit for the wash water to drain into, them pump it up with a sump or effluent pump.
The proper height for a washing machine drain standpipe is typically around 36 inches above the floor. This allows for proper drainage and prevents water from backing up into the machine.
they might get torn up you should hand clean them
If your washing machine is spitting up water it is important to check all the hoses and make sure that the clamps are on properly. If the problem persists contact a repair man or look in the manual.
The whirlpool inlet valve in a dishwasher controls the flow of water into the machine, allowing it to fill up with water at the beginning of a wash cycle.
You can hand wash them in a sink with dish soap. Hang up to dry.DO NOT MACHINE WASH!!!OR DRY!! Plastic WILL rip and WILL melt!!
Your washing machine drain may be backing up due to a clog in the drain pipe or a malfunction in the machine's internal components. To fix it, you can try using a drain snake or a plunger to clear the clog. If that doesn't work, you may need to call a plumber to inspect and repair the drain line.