You need to describe symptoms. Check oscillator frequency and power supply.
Yes, a modulator is required if you use a RF cable to connect it to the TV.
A Philips RF Modulator PH61159 ca be purchased online from Amazon. Also, many online retail websites such as Walmart and Sears carry the Philips RF Modulator PH61159.
To hook up an RF modulator to a DVR, start by connecting the DVR's audio and video output (usually composite or RCA cables) to the input of the RF modulator. Next, connect the RF modulator's coaxial output to your TV's coaxial input. Finally, set the TV to the appropriate channel (usually 3 or 4) that the RF modulator is configured to transmit on, and you should be able to see the DVR's output on the TV. Make sure all devices are powered on and properly configured for best results.
The video out from whatever source you have will go into the RF modulator which then screws into the back of the old TV.
RF Modulator - Convert video and stereo audio from an A/V component into a coaxial cable output Try radioshack.com
by un plug Rf -modulator which is seen on back side
You need a RF modulator to convert the signal to a (RF) TV channel. The audio and video quality will be lower doing this.
As rf modulators are usually mains powered convention says the standard cabling is easier to get
A collector modulator is a type of amplitude modulation (AM) used in RF (radio frequency) transmitters, where the modulation of the carrier signal occurs in the collector circuit of a transistor. The input audio signal varies the base current, which in turn controls the collector current and voltage, resulting in variations of the output RF signal's amplitude. This modulation technique allows for efficient transmission of audio signals over radio waves, as the carrier's amplitude reflects the changes in the input signal. The collector modulator is favored for its simplicity and effectiveness in generating modulated signals.
To connect a digital HDTV to a tunerless DVD recorder, first connect the cable box to the RF modulator using the RF output. Then, connect the RF modulator’s output to the DVD recorder’s AV jacks using the appropriate cables (typically composite video and audio cables). Finally, connect the DVD recorder's output to the HDTV using HDMI or composite cables, ensuring both devices are set to their corresponding input/output settings for proper signal transmission.
An RF modulator is a device that converts video and/or audio into radio waves for use with a television set. In the 1980's, many computers were produced which could be attached to an existing television set. If you were not using a separate monitor, then you'd need an RF modulator to convert the signals of the computer to work with a television. Nowadays, with the new television sets, such converters are no longer necessary, since most televisions now have some of the most common computer connectors and can attach directly using the correct cables.
AF modulator. Audio signals produced by the microphone get amplified enough with the power to modulate the RF carrier wave generated by a RF oscillator.