Clothes driers do not use Transformers, the motor runs at the line voltage.
A transformer made for a clothes dryer is designed to handle higher power loads, typically 240 volts, which is much higher than what an answering machine requires (usually 120 volts). Using such a transformer can potentially damage the answering machine due to the higher voltage output. It is important to match the transformer's specifications with the device's power requirements to avoid any safety hazards or equipment damage.
Detergent should be placed in the designated detergent dispenser or directly into the drum of the washing machine before adding clothes.
before.
You need to read the manual that should have came with the machine, or go on the manufacturer's website for information and to, possibly, download a user guide.
wash it in the washing machine, and put it on normal that should do it.
why should we use pulse transformer rather than ordinary transformer
B.I.L. stands for Basic Impulse Level for the transformer. It should be on the faceplate of the transformer.
If the washing machine only uses hot water, you should use the "hot water" setting for washing your clothes.
If you are talking about your clothes washing machine, it could be that the load of laundry in the tub is unbalanced. Try moving the clothes around so that they are evenly distributed in the machine and close the lid and it should start up again.
no you should not keep air beds in machine because this make clothes very weak and too dry that if we wash again it will just tear off clothes. i tried it........ so i m giving some advise to ......
A transformer can be used to change the voltage to an appliance. The voltage rating of the transformer should be right for the voltages used, and the current rating of the transformer should not be less than the current drawn by the equipment.
dielectric strength is tested by transformer dielectric strength oil testing machine. at first, oil which is to be tested is pour near the two electrode. both the electrode should be dipped in oil . then adjust the distance between the electrode .now start the machine.when a sound came from machine then note down the dielectric strength of the oil.