0
To detach the clip holder from the Longstrike CS-6, first ensure the blaster is fully primed and unloaded for safety. Locate the clip holder on the underside of the blaster; it is usually secured with a tab or latch. Press the tab down or slide it in the direction indicated, then gently pull the clip holder away from the blaster until it disconnects. Always refer to the specific instructions in the user manual for your model to avoid damage.
What else can I help you with?
Can you take the stock off a longstrike cs6?
NO!
Can you use the Nerf recon cs6 clips on the Nerf longstrike?
yes
Can you use the Nerf recon cs6 clip in the Nerf raider?
yes
How many darts does the Nerf deploy cs6 clips hold?
It comes with 6 and a clip that can hold 6.But you can get a clip in the stampede that can hold 18.But you can get clips of 18 in some toy shops.
How do you take apart your longstrike cs6?
To take apart the Longstrike CS-6, first ensure the blaster is unloaded and remove any clips or darts. Begin by unscrewing the screws located on the body of the blaster, typically found on the underside and near the front. Carefully separate the two halves of the shell, taking care not to damage any internal components or wires. Once opened, you can access the internal mechanisms for modifications or repairs.
How do you put the Nerf recon cs6 on the bandoiler belt?
You can, but I have tried it and only the pistol mode with no acessoreis (even the clip) will fit in if you stretch one of the clip holding things really hard and slide it in. I have tried to put in the nite finder and the maverick, but they barely fit into the clip holders just like the recon.
What is the name of the Nerf gun that has a scope?
Easy, if you prefer normal scopes like acog, choose the "Longshot scope." If you like futuristic scopes look up the "Centerfire Tech Electronic scope."
Is there a C4D After Effects plug in for CS6?
yes there is infact a C4D after effects plug in for CS6 you
Does the MacBook Pro 2.33 run cs6?
CS6 has been tested, and runs on Mountain Lion. CS6 is 64 bit only. The FAQ page is adobe.com/products/creativesuite/faq.html
How do you put the Nerf bullets back into the clip?
well if your talking about the clip,you just put the dart in ,but when you put the second one push the first down then put the second one in then just keep doing that and thats how you put darts back in into the nerf recon cs6 by:jrock 54.
Where does the Nerf-N-Strike Re con CS6 darts stick to?
The Recon uses Clip System darts which do not stick to anything. There are many blasters, like the Firefly and Maverick, which do come with suction-tipped ammunition.
How much is the longshot-cs6?
30$.
