you cant it is basicly impossible i know because i tried and no sucsess
Streamline foam darts with drum/clip. Or: if you are able to, manually load any other dart that can fit in the barrel, BUT this is not recommended.
On the bottom (not the stand) there are many screws. Just unscrew them to open the drum set.
you have to pull back a little hard, or pull back the top orange part and take out the Nerf dart. if that doesn't work get a new gun.
Both guns are of supreme quality and performance. The Alpha Trooper has slam-firing and 18-round drum clip. Out of the box, it gets 30+ ft. ranges. Good for assault. The Longshot is a bolt-action clip system blaster that can fit an extra clip (it comes with an extra one) in the stock. You can take off the attachment, which is a failure of a gun (gets 10-15 ft. ranges out of the box). Out of the box, the Longshot gets 35+ ft. ranges. I suggest Alpha Trooper if you want to go all-out, and Longshot if you want to snipe of enemies 1 by 1. As for modding, the Longshot has crazy modding capabilities. With a few simple mods and removals, the Longshot can break 50 ft. Hope this will help.
4.4 years from here
You have to take the mag, and screwdriver (+). Unscrew all screws on the mag, then throw it in the toilet. Go to Evike or ASGI and get a Drum or Beta mag!
take the wheel off, take the break drum off, take a picture of what it should look like, take it apart, put new pads on, and then put it back together.
If you just need to fix up the drum pad sensitivity, the pads snap off and on easily. (Disclaimer: I have Rock Band 1 drums for the Wii, so I'm not responsible if this isn't true for RB2 drums too) If you want to take it apart for another reason, just snap off the drum pads and unscrew all the screws.
Buy brakes, new spring kit, anti seize grease. Pop hood loosen brake cap. Loosen lug nuts, jack up car, put in jack stands, take off wheel, take off drum, tap drum with hammer if stuck. Then get paper and pen and take very detailed notes. Take things apart by pushing in on spring caps and twisting. Put anti seize on lug nuts and where drum meets. If you want to replace the piston , you should know that the piston may be too big to come out of it hole, so you would have to take more things apart.
Take apart one side and leave the other side together so you have one to view for reference.
Take My Drum to England was created on 2005-08-25.
To take a washing machine apart for scrap, first, unplug the machine and disconnect it from the water supply. Remove the outer casing by unscrewing any screws and carefully prying it off. Next, take out the drum by unscrewing it from the motor and separating the components, such as the pump and wiring. Finally, sort the metal, plastic, and other materials for recycling.