How do you make a water grenade?

Answer 1

Fold a square sheet of paper diagonally,unfold, then repeat in the opposite direction. At this point, the shape of an "x" should be apparent from the folds. Turn the paper over, then fold in half from top to bottom. Turn it again, press in the middle, fold in the flaps on the side. The paper should be in the shape of a triangle. Fold the front-side flaps to the middle. The shape should now be square. Fold the side corners to the middle. Pockets should form, tuck the flaps into the pockets. Repeat the steps on the opposite side. Blow in a little hole to inflate it. Fill with water.

Answer 2

A water bomb or water grenade is a classic summer toy. Simply fill a small balloon with water, tie a knot, and throw. The worst that can happen is that you get wet which is the whole idea behind the toy.

Answer 3

there are lots of ways to make a watergun. One is have a bycycle pump tube and stick it in a strong water/fluid bottle, have PVA glue around it. Cut a hole in the bottem and stick a small hollow rod,if you want the water to go far, have a small hole however this will reduce the amount of soakage. I would recommend a hole about 3 millimeters across and down. Don't pump it up to much or it will have too much presure and explode. pump it to around 65 PSI (pounds per square inch). Have fun.

Answer 4

fill a balloon with water

hope this helps :)

Answer 5

you dont