DC Collectibles Comics Designer Action Figures Series 2
go a head, there's millions
you have to push the head on. be careful because you could brake your doll
Just pull it off then press the other one in until it clicks :)
To reattach a Journey Girl doll head, first, ensure the neck peg is intact and clean any residue from the neck area. Align the head with the neck peg and gently push down until you hear a click, indicating it’s securely attached. If the peg is broken, you may need to use strong adhesive or a replacement peg to reattach the head properly. Be cautious not to apply too much force to avoid damaging the doll.
It's a Jabba The Hut figurine with a detachable head. You put the slimey stuff with frogs [which comes with the toy] into the head, then reattach the head then it like spews it out again.
In a story, the climax is where all of the action comes to a head. It is usually the most exciting part of the story, and most everything that comes afterward is falling action that moves the story toward a conclusion.
Roman Catholic AnswerJesus Christ is the head religious figure of the Catholic Church.
Figure It Out
to get jet the hawks head off you have to get a fine pir of tweasers. then you have to gently go in to the joint. after that it gets tedius.you have to keep carefully pushing trying to grac the bottom of the head. once you have done that you have to move the joint at the bottom of the head. after about 5 minutes you will be able to just take it out.:~)
To reattach the head assembly to the body of a Norelco 7825XL shaver, align the head assembly with the body so that the guiding tabs fit into their respective slots. Gently press down on the head until you hear a click, indicating it is securely in place. Ensure that the assembly moves freely and is properly seated before using the shaver again. If necessary, refer to the user manual for specific instructions related to your model.
A billemann is a figure skating spiral where the figure skater has their foot above their head from behind.
I prefer an adhesive like PL300 or silicone for this. -If it has to be pulled tight you will have a problem, whatever you use.