answersLogoWhite

0

  1. the answer is only 10 min long ands super easy!!!!!!!!!!!!!!
  2. The clues are key. thay may seem cryptic,. it takes about 10 min. to open the isis once you know how.
  3. as clue 4 suggests, the rings don't do much.
  4. the only other thing im gonna tell you is to release bb3, you must bash it plunger up, then move bb3 into the middle of the maze. that's it
  5. --
  6. Actually, here goes. 1:st, plunger up and, as said, bash it quite hard (to release a small metal ball that will then fall from its hanging position by a magnet. This ball will then fall down into a hole in a base plate (the base plate is the locking mechanism). After this banging, you need to rotate the orb in air in order for the small ball to end up in the center of the plate. Do that. Try to see if you are sucsessful in doing that by pressing the button, if the button goes only half way down you are good. If not,(the button goes all the way, bad) keep rotating. When sucsessful keep the button down, turn the orb around. When doing this, the plunger actually holds the ball still in its centre. When upside down, rotate the orb so that two other balls fall into their crevices. Now, final step! Press the button all the way up! This will now lift the locking plate so that it's freeing the locking. Turn the ball around again holding down the button. Release it slowly. Now be very careful! Do not bump the orb at all, start unscrewing it slowly and carefully. There you go! That's the secret of the ISIS I.
  7. On the same subject; how to reset your puzzle ball? First of all: keep the ball in the plate! If you remove it, you will never be able to reopen your puzzle (unless sending it in to Sonicwarp, where they probably will use a slinshot centrifugal).
  8. If you remove the locking plate, make sure that the hole aligns to the outer marking! And; maker extremely sure that the 2 balls are in different grooves! If they are in the same groove, one will always stop you from opening your orb again! Ever. You can actually test that you have got this right; rotate the half by its own and, then press the locking plate up. If it goes up fluch, then you are good. By removing the balls you remove this 'switch', making it a little bit easier to reopen your orb!
User Avatar

Wiki User

13y ago

What else can I help you with?