answersLogoWhite

0

It's just what it sounds like: a RC transmitter that sends nine channels of data to the model.

What it DOESN'T say is why you'd want that many. You have a plane...say it's a P-38, which has two engines. You need at the very minimum:

rudder channel

elevator channel

aileron channel

throttle channel

Real P-38s have retractable gear so throw in a fifth channel for the retracts. And for many years, that's all you had.

Then you might want a channel for flaps, some guys split the ailerons into two channels, you might want to make the plane drop model bombs so that's another two channels (one for the doors, one for release)...already you're at nine channels and you haven't added your landing lights, smoke system or whatever other things you might want on the plane.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Can an am crystal be used in a FM RC radio RC transmitter?

No


What is the function of an RC transmitter?

An RC Transmitter will transmit the signal from your remote to the RC vehicle, allowing you to control it's movements, drive it around within the signal radius and perform tricks.


Explanation of telephone transmitter?

Explaine input Transducer,Transmition channel,Transmitter,reciever,output transducer.


How do you add channels to a RC transmitter?

http://www.rcgroups.com/forums/showthread.php?t=55575 If your tx uses the same encoder as that one then it can be done. There was a link to an old forum on that site as well about a four channel mod that could be done to a transmitter but the forum with it on has closed. Hope it was of some use.


What are synonyms of conductor?

transmitter, wire, channel, conduit, director, pilot


Is any type of transmitter is appropriate for mini RC car?

Any type of transmitter is fitting for the mini RC cars, all though the transmitter may need to be new because their company has made some changes. The old transmitters are slightly out-dated. So if you use an old transmitter it would not work. Hope this helped. •~••~••~••~••~••~••~••~••~••~••~••~••~••~••~••~••~••~••~•


How do you test an RC transmitter to see if its transmitting?

To test an RC transmitter, first, power it on and ensure that it is connected to an RC receiver or a compatible device. Use a spectrum analyzer or an RF signal meter to check for output signals at the designated frequency. Alternatively, you can observe the receiver’s response to control inputs from the transmitter, such as moving the sticks or switches and verifying that the receiver responds accordingly. If the receiver lights up or reacts as expected, the transmitter is functioning correctly.


What channel on the transmitter controlled the left drive motor on the basebot?

The left drive motor on the basebot is typically controlled by one of the channels designated for motor control on the transmitter, often channel 1 or channel 2, depending on the specific configuration of the robot. In many standard setups, channel 1 is commonly assigned to the left motor, allowing the operator to control its speed and direction. However, it's essential to refer to the specific transmitter and robot manual for precise channel assignments.


What is a creation of a communications channel for a transmission from an earth based transmitter to an orbiting satellite?

uplink


What is The capacity of a communication channel?

The transmission capacity is based on a formula describing the power between a transmitter and a receiver. The ratio of these two numbers and the formula describes the capacity of the channel.


Hiiiiiiiii i want to control 9 bicoloured led through infrared transmitter and receiver can anybody help me with the transmitter receiver part?

It is easier to buy then to biuld try sparkfun.com they have small receivers transmitter


What is The transmission capacity of a communications channel?

The transmission capacity is based on a formula describing the power between a transmitter and a receiver. The ratio of these two numbers and the formula describes the capacity of the channel.