Coolant temperature sensor is located on the front of the engine. The coolant temperature sensor is a few inches above the thermostat housing.
where is the thermostat on a 1.4 1997 ford fiesta zetec engine
The thermostat on a Ford Fiesta Zetec S is typically located near the engine, often at the end of the upper radiator hose where it connects to the engine block. To replace it, first, ensure the engine is cool, then drain some coolant, remove the hose, and unbolt the thermostat housing. Replace the old thermostat with a new one, ensuring the gasket is properly seated, and reassemble by reversing the disassembly steps. Always refill the coolant and check for leaks afterward.
The thermostat on a fiesta zetec engine is under the air box. The air box and splash guard will need to be removed for access.
To bleed the cooling system on a 1.6 Zetec S Fiesta, first ensure the engine is cool and the radiator cap is off. Start the engine and let it run until it reaches operating temperature, allowing the thermostat to open. Keep an eye on the coolant level and add coolant as necessary while squeezing the upper radiator hose to help release any trapped air. Once the air bubbles have stopped and the coolant level stabilizes, replace the radiator cap and check for leaks.
There is no such thing as a: temperature switch, on your Ford focus, the coolant temperature sensor is located on the front of the engine.
If it is a mk4 onwards model it is on the front of the engine under the alternator sitting in the plastic housing
Should be at the engine end of the upper radiator hose
Follow the top radiator hose to where it meets the housing that goes into the driver's side of the engine, the thermostat is in that housing.
To bleed the water system on a 2000 Zetec-S Fiesta 1.6, start by ensuring the engine is cool. Remove the expansion tank cap and top up the coolant if necessary. Run the engine until it reaches operating temperature with the heater set to maximum. Keep an eye on the coolant level, adding more as air bubbles are expelled, and ensure there are no leaks before replacing the cap.
Usually in a removable housing at the engine end of the upper radiator hose
For the 2000 Ford Focus , 2.0 L ( SPI and Zetec ) The engine cooling system capacity is : ( 5.75 litres / 6.1 U.S. quarts )