The hotel toilet may not flush properly due to clogs in the pipes, a malfunctioning flush mechanism, or insufficient water pressure.
On the inner rim of your toilet where the water flushes out from the cistern, if these small holes are blocked it wont make the right angled pressure to flush a toilet
Yes that is normally the problem with a blockage
just give it a full flush in your toilet. Oh i believe a half flush wont work!
Get your hair spray out and spray them down so that way they wont move when you get a napkin and flush them down the toilet
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
They live till you find them and you kill them but if you flush them down the toilet they wont survive because they drowned in water!!
If your plunger is left in the bowl. :) Since I've been snaking out toilets for many years I come to the conclusion that when a toilet doesn't flush right, the reason is like lightening and it never strikes the same reason twice. So your problem of your toilet not flushing smooth can be a million different problems but 90% of those problems are in the toilet bowl trap. If you plunge and snake the toilet and it still wont flush right then pull the toilet and look at the drain and if its clear then your problem is still the toilet which since china makes stuff so cheap , its almost cheaper to buy a new toilet then to buy the repair kit for your old one, in fact to have me repair your toilet and to have me install a new toilet with buying the toilet would be about the same price so almost everyone gets a new toilet and we live happily ever after.
You shortened the chain too much. Make it longer a link at a time till it works.
If your toilet bowl isn't fully flushing, it could be due to a few issues. Check for clogs in the trap or drain line, as even partial blockages can affect flushing power. Additionally, inspect the flapper valve to ensure it's sealing properly and that the flush mechanism is functioning correctly. Lastly, consider whether the vent pipe is obstructed, which can affect drainage and cause poor flushing performance.
A plunger is only going to help if the plug is in the toilet itself. It may be further down the drain. You could have tree roots in the line. A simple fix that may help is this. Get a 5 gallon bucket and fill it with water. Pour it in the bowl as fast as it will take it. Bring the water level in the bowl up to the bottom of the rim and keep pouring until all 5 gallons is used. This is a much greater volume of water that the toilet normally send down the drain and may flush out a partial clog. It will not hurt anything if it does not help.
that is an opinion so u wont get a straight answer
You have to clog the toilet with toilet paper to have the janitor come and then you can grab the nickel