answersLogoWhite

0

γ Back-off angle or clearance angle L w Length of the workpiece (not shown.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you sharpen a cutting tool for a lathe?

You should know the angle of the cutting tool. You can use emery sharp cutting tool.


What are the function of clearance angle?

The clearance angle in machining refers to the angle between the cutting edge of the tool and the surface of the workpiece. Its primary function is to prevent the tool from dragging against the workpiece, which can cause excessive wear or damage. Additionally, an appropriate clearance angle enhances chip removal, reduces cutting forces, and improves the overall surface finish of the machined part. Properly designing this angle is crucial for optimizing tool performance and extending tool life.


What is taper turning on lathe machine?

An operation performed on a lathe that feeds a tool at an angle to the length of the workpiece in order to create a conical shape.


How short tapers are produced on a job in a lathe?

Short tapers on a lathe are produced by using a compound rest or by adjusting the tailstock angle. The workpiece is set at an angle, allowing the cutting tool to remove material progressively, creating a gradual taper. Additionally, the lathe can be set to a specific angle using a taper attachment or by manually adjusting the tool's position. This method ensures precise control over the taper's dimensions and length.


What is a right hand knife tool lathe?

it is a tool used on a lathe to cut metal from right to left


What tool is a square?

tool post is used to handle the tool on the lathe machine


What are the function of tool post?

This is the place to close on the lathe cutting tool.


What is a square tool post?

tool post is used to handle the tool on the lathe machine


What is the purpose of the sideways of a lathe?

rest your tool on


What is carriage in lathe machine?

carriage is a part of lathe which means to be support cutting tool to give feed to cutting tool and control cutting action.


What is the difference between center lathe and capston?

The centre lathe has only one coaxial tool, whereas the capstan has a rotating multi tool station with indexer and clutch.


Set a tool in a metal lathe at what angle?

Cutting tools for facing and outside diameter turning are set to an angle of 90 degrees to the bed. Boring tools are set to the same angle as the bed. Cutting tool tips are already angled to suit its purpose and there's usually no need for further adjustment. They can be set against the inside of the toolpost and fastened.