Gun shop, gun show, egunparts
If you removed the bolt, you probably lost the ejector spring. A new one can be had from Numrich Gun Parts. To replace the ejector spring, remove the bolt, and take out the spring from the bottom of the receiver just behind the ejector port.
open the breech bolt and check the ejector, is a steel wire located betwin the breecch bolt and the action maybe is too wear
To remove the ejector and extractor from a Savage 110 bolt, first ensure the rifle is unloaded. Disassemble the bolt by removing the bolt handle, then use a small punch to drive out the retaining pin that holds the extractor in place. Carefully lift the extractor out, and then remove the ejector spring and ejector by pushing them out from the rear of the bolt. Always refer to the manufacturer's guidelines for specific instructions and safety precautions.
To repair the ejector on a Western Field 12 ga Model ENH-560-8A shotgun, first ensure the firearm is unloaded and safe to work on. Disassemble the shotgun by removing the trigger group and bolt to access the ejector. Inspect the ejector for wear or damage, clean it thoroughly, and replace any broken parts if necessary. Reassemble the shotgun and test the ejector function by cycling dummy rounds to ensure proper operation.
no. the bolt is push feed with a button ejector and plate extractor vs. a standing blade ejector and mauser style claw extractor in the pre 64's.
To install the cartridge ejector spring in a Marlin 81DL, first ensure the rifle is unloaded and safe to handle. Remove the bolt and locate the ejector housing; insert the ejector spring into the housing with the coiled end facing the ejector. Carefully align the ejector with the spring and press it into place, ensuring it is seated correctly. Finally, reassemble the bolt and reinsert it into the receiver, ensuring everything functions properly.
Bolt and bolt carrier group
To repair the bullet ejector on a Springfield .22 caliber Model 187 series A rifle, first ensure the rifle is unloaded and safe to work on. Disassemble the action to access the ejector; this may involve removing the bolt and other components. Inspect the ejector for damage or wear, clean it if necessary, and replace any broken parts. Reassemble the rifle, ensuring that all components are correctly aligned and secured before testing the ejector's functionality.
I would go to numrich gun parts corp. they are on the web.I would also check E-gun parts.com.
ejector also
Take bolt apart take bolt head and clamp in a drill press use a 3/32 drill bit to drill it out shouldn't have to drill all the way out . Numrichs brownells and midway usa have the ejector the spring and the retaining pin
The ejector located inside the left side of the receiver is drug reward by a leaf spring on the bolt on this rifle. The ejector has a shoe on the forward end which is part of the chamber and assists the extractor in removing the cartridge from the chamber. About halfway to the open position a coil spring located in a slot on the left side of the receiver under the thin metal cover overcomes the bolt spring pressure and pops the ejector loose and returns it to its forward home position. As the bolt continues rearward a lip on the back end of the ejector contacts the cartridge case rim and kicks it out when the bolt is fully rearward.