0
"Titration" or "titrated" in chemistry, refers to adding one chemical to another, a little bit at a time, to get the two chemicals to provide a certain reaction.
"Titration" or "titrated" is used medically to figure out drug dosages in at least two ways.
1.) It may be to take as little of a drug as possible to get the desired effect. For example, the doctor may start you on 10 mg, and if that is ineffective, gradually increasing the dose to get the maximum effect with the least amount of the medication.
OR
2.) Often used in treatments such as chemotherapy, this method is where you gradually add the drug/treatment dose until the side effects outweigh the benefit of the drug, which is normally only done in the early stages of clinical trials.
Reference: http://patients.about.com/od/glossary/g/Titration-Or-Titrated-The-Definition-Of-Titration-Or-Titrated.htm
What else can I help you with?
Why you use tritation?
there are many uses of titration..to know the volume of one drop of a liquid..
How does tritation work?
Titration is a technique used to determine the concentration of a substance in a solution by reacting it with a solution of known concentration. A burette is used to carefully add the titrant (known solution) to the analyte (unknown solution) until the reaction reaches a specific endpoint, indicated by a color change or another observable change. The volume of titrant added is used to calculate the concentration of the analyte.
Which reactant is the source of the O2 product in this tritation?
In a typical titration involving the production of O2, the source of the O2 product is often a reactant that undergoes a chemical reaction that releases oxygen. For example, in a reaction involving hydrogen peroxide (H2O2) decomposing, it is the hydrogen peroxide that serves as the source of O2 when it breaks down into water (H2O) and oxygen gas (O2). Depending on the specific reaction being studied, the exact reactant may vary, but it is typically one that contains oxygen in its molecular structure.
How do you prove sulfuric acid is dibasic?
by carrying out a tritation and using your readings in calculations to determine the molarity of the acid against what you are reacting with it. you should find that 1 mol of H2SO4 relaeses 2 moles of hydrogen ions
Why murexide is prefer over eriochrome black t in estimation of nickel with edta?
Both indicators may be used, for example if you have no other kind in the lab. Murexide is used normally as its blue/purple end point for the tritation is more easily observed. Also less murexide is needed for titrations, this is a good thing since indicators by and large are weak acids or bases themselves, thus mimising the impact on the titration figures.
