answersLogoWhite

0

What else can I help you with?

Related Questions

How do you remove rear seat in a 2009 rav4?

Under the seat, towards the rear of the seat, there is a splice in the cable that goes to the back of the vehicle. This cable connects to the levers just inside the back door that allow the seats to be folded while standing behnid the vehicle. This splice is black plastic- about an inch in diameter and about 2.5 inches long. In the center is a grey clip that holds everything together. Remove the grey clip. Rotate the splice until you see a split on the rear that will allow the rear cable to pass through. Turn the splice 90 degrees so the cable finds its way through the splt. The ferrule on the end of the cable can then pass. Good Luck PocoJoe Tucson AZ


How do you splice a ground wire?

Strip the wires back about 3/4" and then using lineman's pliers twist the wires together about 2 turns. Tighten a wire nut securely to the connection. Then tape the splice securely with electrical tape.


What is a wire Lap Splice?

It is the same type as the western union splice, where the two wires are overlapping and wound back on the opposite conductor.


How do you splice electrical cord back together?

To splice an electrical cord back together, you will need to cut the damaged part of the cord, strip the insulation from the wires, twist the matching wires together, cover them properly with wire nuts or electrical tape, and finally cover the repaired area with a heat shrink tube or electrical tape for insulation and safety. It is important to ensure the wires are properly insulated and the connection is secure to prevent any electrical hazards.


Illusrations of common wire splices and joints?

You can splice wires together in many ways. You can solder them together and then tape them up or use a shrink insulator that shrinks by heating it up. You can strip the wires back about 1/2 inch and then twist them together and put them under a wire nut. Wire splices in a home must be spliced together inside a junction box with a cover. Wires can never be spliced behind a wall. Any splice should be placed where you can access it later on.


Can the broken hood release cable for a 1996 Jeep Cherkee Sport be reattached at the pull handle by crimping it together?

Yes you can crimp the hood release cable back to the handle.


Who manufactures Nintendo Entertainment System?

Nintendo, and that was back in the eighties


What is the purposes of splicing wire?

The purpose of splicing wire is to extend the wiring to further the distance of the circuit. A main feeder from a distribution panel can be spliced to supply voltage to more that one circuit. This is a money saving procedure as each separate circuit does not have to be brought back to the distribution panel. In underground direct burial feeds that have been dug up by a back hoe, a splice is the only way to restore power short of installing new cable. Special underground splice kits are used to restore the insulation factor of the cable, which usually leaves the cable with a better insulation factor at the break than that of the original cable insulation.


How do you hook the e brake cable to the shoe?

all you do is you dismantle the whole thing and then put it back together, but disconnect the e-brake cable and connect it to the front brakes and automatically it will apply to the back wheels when pressing the foot brake. hope that helped


Can your 3ds break if you play it while charging?

Yes, you can. Just unplug the charger from the charging cradle and plug the charging cable into the back of the 3DS.


Who invented Nintendo wii?

That would be Nintendo back on November 19th, 2006.


Will there be a splice 2 movie?

Hell yeah Yep there will definitely be a splice 2 because of the ending of the first splice and also because I have been searching the net and splice 1 was not supposed to have a sequel but after the ratings of splice 1 the creator of splice 1 has decided to make a splice 2 the rebirth.