You should have labeled them and installed them in the exact same position as they were in. If you did not, then, all you can do now is guess.
There are a total of 12 pushrods on a GM 3.1 V6 engine from 94 through 2005. 6 are 5 & 3/8 the other 6 are 5 inches. They are for intake and exhaust pushrods. The best way is to install them and place them back where you took them off but if you didn't you will have to install them back and observe that the pushrods that are in a slight angle are the long ones. The short ones are straight down. You should always place your lifters, pushrods and valves where you took them off but I know that many people make mistakes since we are humans. Also look at your cylinder heads and see where the intake and exhaust valves are.
123456
165432
In GM trucks or new GM cars, the 8th digit of the VIN # is the Engine.
GM?
There is no 3.6 L GM engine. The 3.1 & 3.4 V6 firing order are 1-2-3-4-5-6 The 4.6 V8 is 1-2-7-3-4-5-6-8
10248880 Engine
The GM 4.3 firing order, 1, 6, 5, 4, 3, 2. CW.
The GM5.7LG SGI 10243880 is typically associated with a specific model of the General Motors (GM) engine, particularly the 5.7-liter V8 engine used in various GM vehicles. This engine was commonly installed in models like the Chevrolet Silverado, GMC Sierra, and other GM trucks and SUVs from the late 1990s to early 2000s. It is known for its performance and reliability in those applications.
to my knowledge a windsor 351 is a ford engine. so how would you evem match a gm distributer cap
1, 8, 4, 3, 6, 5, 7, 2.
There is none. GM does not install inertia switches on their vehicles.