0
I'm not sure what you mean by "dip" and "main", but if you mean when you switch from low beam to high beam, then the problem most likely is in your turn signal lever. There may be a dead area in between pulling it back (low beam) and pushing it forward (high beam). I had this problem on a '98 Grand Marquis. Make sure the lever is all the back on low beam until you get it repaired. I would not recommend switching to high beam before then.
try replacing one of the bulbs on one side first, you may just have the high-beam element burnt out in both bulbs
What else can I help you with?
Where is the switch for Bright lights on Lincoln Town Car?
i have a 96 Town car and the high/low beam switch is on turn signal. push signal switch forward for high, back for low.
Why does the low beam headlights of my 1990 Lincoln Town Car not come on?
Try looking at the low beam fuse it may be blown. If no other lights come on it could be the switch.
Head lights wont come on on a 1999 Pontiac Montana what could be the answer the fuses have been check and the light bulbs?
I had a car that had a failed combination switch (the turn signal, hi-low beam, parking lights switch). I could get the lights to come on if I set the switch to high beam, but not low. A new switch and, viola! Verrry expensive to have dealer repair. If this is your problem, hopefully you have a mechanic friend.
Why does the 89 Pontiac sunbird le highbeam lights wont work when you move the switch Changed highbeam bulbs Is it the switch or electrical problem Low beam lights work fine?
I have the exact same year, model etc. The high beam doesn't have a switch.. You pull the blinker switch towards you. That is how high beams work on this car. The slider bar located near the lights dims and brightens the dash board lights.
Why would all your car lights fail?
the light switch controls all lights normally, it takes power from the battery and distributes it to the lights by several different wires, hi beam , lo beam, tail , dash, etc. Of course check all the fuses first , and the fuseable linkwires if equipped.
Is there a constant hot going to a cars tail lights?
There is no electricity going to the lights of an automobile if the light switch inside the car is off. The main switch cuts off all current to the lights, both front and rear. There will be current to the tail lights if the brake is applied.
Why the rear lights of your car are on with the car off?
The rear lights of your car will still on even if your car was off because the switch was turned on and it will still remain on until the battery's out. Another possibility, if the headlight switch is off and the ignition switch is off, the brake light switch may be out of adjustment or broken and what you're seeing is the brake lights on.
Why my car low beam works but not high beam?
You need to replace the bulbs in the lights.
What are dual beam headlights?
Car headlights have to be able to "dip" so as not to dazzle oncoming traffic, they therefore can switch between a "high" beam and a "dipped" beam and thus have a dual beam.
Where is the multi-purpose switch for a 1995 olds aurora?
A multi-purpose switch is the blinker- high beam switch on the stearing coulm of the car.
When driving behind a car at night what distance should you turn down your high beam lights?
when you see there tail lights. White lights travel farther then red lights.
When driving your car at night with your high beam on at what distance should you lower your lights when you approach another car?
500 feet
