Yes
I utilize liquid shock and poor it near the return...this way is disburses and spreads out into the pool. The power shock can sometimes sink to the bottom and sit there for a while...not the best for the liner.
No liquid shock is more concentrated
It depends on the percentage . I have never seen liquid shock in strength of granular .
To shock a pool with liquid chlorine effectively, first test the water to ensure the pH and chlorine levels are balanced. Then, pour the recommended amount of liquid chlorine into the pool while the filtration system is running. Allow the chlorine to circulate for several hours before swimming. Remember to follow the manufacturer's instructions and safety precautions when handling and using liquid chlorine.
one pound of cal hypo, granule chlorine, will treat 10,000 gallons of pool water. So use 1/4 pound to shock, two or three times that if pool goes green. If pool has a vinyl liner use sodium hypochloride, liquid shock, instead of granules.
Shock in a compressor refers to the sudden increase in pressure due to a rapid change in operating conditions, such as starting and stopping the compressor suddenly. This can cause mechanical damage and reduce the lifespan of the compressor. Proper control and gradual changes in operating conditions help prevent shock in a compressor.
To convert powder pool shock into liquid shock, dissolve the recommended amount of powder in water according to the manufacturer's instructions. Typically, you would add the powder to a bucket of water, stirring thoroughly until it is completely dissolved. Once fully mixed, you can then pour the liquid solution into the pool, ensuring even distribution. Always wear protective gear and follow safety guidelines while handling chemicals.
The best solution and have found (and done many times) is liquid laundry soap and a good wide tire scrub brush. The generic laundry soap seems to work the best! You can get a cheap bottle at your local $$ store. The wide tire brush is stiff enough to clean, but soft enough to not rip the liner. I put the soap into a wide angle spray bottle and sprayed about a 1 ft section at a time. Then scrub and rinse as you go. It is time consuming, but it will work to remove the stains, new algae, and restore the liner material. Most chemicals actually slowly deteriorate the liner! Also works great on the outside of the vinyl and soft side pools.
Olympic swimming pools use about 650000 gallons of water, so if you're trying to shock one using 10% liquid chlorine, you would need about 200 gallons of liquid shock - or if you're only adding choline as a primary sanitizer, not as a shock, you'd use about 65 gallons.
Don'Bother with the liquid algae control it will just stain your pool, Use an apropriate amount of liquid chlorine, this will kill the algae at the same time shock your water.
Winning the lottery jackpot came as quite a shock, I've never won anything before!
Shock occurs due to massive bleeding and pain. Losing an arm will put a person into shock. Trauma will likely kill a person before it puts one into shock.