Yes ! Better than bleach! no brushing
To use pool shock effectively for maintaining clean and clear water in your pool, follow these steps: Test the water: Use a pool water testing kit to check the chlorine and pH levels in your pool. Calculate the amount of shock needed: Refer to the instructions on the pool shock product for the correct dosage based on your pool size and current water conditions. Dilute the shock: Dissolve the pool shock granules in a bucket of water before adding it to the pool. This helps prevent staining or damage to the pool surface. Apply the shock: Pour the diluted shock solution around the perimeter of the pool while the filtration system is running. This ensures even distribution of the shock throughout the water. Wait and test: Allow the shock to circulate in the pool for several hours or as recommended on the product instructions. Test the water again to ensure the chlorine and pH levels are within the desired range. Repeat if necessary: If the water is still cloudy or algae persists, you may need to shock the pool again or consult a professional for further advice. By following these steps, you can effectively use pool shock to maintain clean and clear water in your pool.
If a child or for that matter an adult vomits in the pool you should clear the pool clean out the material vomited into the pool by netting skimming and vacuuming. Shock the pool and leave overnight to be on the safe side.
Rephrase the question. What type of shock have you used? Is it a calcium based shock treatment? Supply more info.
five pounds
Shock it. Sold at Walmart, Lowes, or possibly your grocery store.
Clean out any bits and pieces and shock it. after that it should be fine.
Clean your filter!!
SHOCK!! Its a powder you can buy at a pool store or chemical store.. its chlorine in powder form, you just dump it in your pool stir it up a bit, wait a day or two, and the pool should be clean.
No, Oxi Clean is not intended for use in pools. You should go to a pool supply store to learn what chemicals to use and the correct amounts for the kind and size pool you have.
Backwash first then shock. If you shock and then backwash you will be throwing away the shock you just put.
shock the pool add algaecide and scrub the pool walls with a stiff pool broom this should take care of the problem within a couple of days.
To clean a pool efficiently, start by skimming the surface to remove debris, then brush the walls and floor to loosen dirt. Use a pool vacuum to remove debris from the bottom. Test the water chemistry and adjust as needed. Finally, shock the pool to kill bacteria and algae. Regular maintenance will keep your pool clean and clear.