No. Curved shower rods have a unique crescent shape that keeps the water from getting on the floor. They also give you more physical space in the shower. Many hotels are using these shower curtain rods in their hotels.
As long as care is taken to insure that the shower liner remains inside the tub, there should be no water leakage.
Yes. Tub or shower water entering the wall through loose tiles or grout can run down the pipes, through the holes the pipes are going though, and into the unit below. It is more common for water to get into the unit below from leaking shower doors or poorly used tub/shower curtains that allow water to leak out the face of the tub/shower. It then enters the gap where the tub/shower meets the floor, then builds up on the sub-floor, and eventually into the unit below.
The purpose of a vertical shower door seal strip is to prevent water from leaking out of the shower enclosure. It contributes to the functionality of a shower door by creating a watertight seal between the door and the shower frame, ensuring that water stays inside the shower and does not leak onto the floor outside.
To shut off the water to the shower in case of a leak or maintenance issue, locate the shut-off valve for the shower. This valve is typically located near the shower or in the basement. Turn the valve clockwise to shut off the water supply to the shower.
If it's a simple water leak your insurance company probably won't offer much help. a plumber will take care of the leak but then you'll need to get a contractor to patch up the water damage.
Possibly, but the supply lines should be in the wall. Even on a slab house, the water should come into the house at the water heater and then be in the walls. Possible heat vent leak? I'm assuming a slab house because if there was access underneath, you would be able to tell if there was a leak.
The shower may be leaking from: 1) A failure of the drain and associated piping itself (e.g., corrosion of the cast iron floor drain), 2) A failure of the shower pan, which is an ostensibly waterproof liner (may be metal or synthetic polymer) embedded in the tile floor (or comprising the plastic floor) which is mechanically connected to the drain; or 3) Leakage of water in the shower's surrounding area (walls, non-pan floor area, etc.) which is accumulating and dripping near the drain.
Water is dripping from the shower head because there may be a leak in the shower head or the faucet handle is not fully turned off, causing water to continue flowing.
All showers need valves. They can be for the water supply, balancing the water and control of the shower. Without the valves, your shower will leak, causing damage to the surrounding areas.
If you have a new pressurised water system there is a possibility that the added water pressure could cause a leak.
Plumbing, Leak Detection, Water Heater Leaking, Hot Water Heater Leaking, Leaking Shower, Leak Repair, Water Leaking, Leaking Pipe .
The tub faucet leaks when the shower is turned on because the diverter valve, which directs water flow to the showerhead, may not be fully closing off the water supply to the tub faucet, causing water to leak out.