You could try using a plummers snake, or an electrial snake, put it down the pipe and go until you find the clog then twist and try forcing the snake forward, this may take many trys before you are sucessful, if you feel you have mouved the clog try running the pump to pull the clog free from the pipe and send it to the pumps skimmer collector.
Take your snake on the roof and clean the drain from the vent.
The main line drain is clogged or septic yank needs clean out.
i think rain water has clogged in your phone line.call your operator and tell him to clean it.
In order to vacuumn the pool you must first put in the vacuum and the hose. You can siphon the air out of the hose by putting it in front of the return to dispace all air in the hose line. Then turn off the pump. Insert the end of the vacuum line either into the port at the bottom of the skimmer in the pool or remove the skimmer basket and insert it in the bottom of the skimmer. Then after the line is secure, turn on the pump motor. Your vacuum should be ready to use (manually) or run automatically if you have an automatic pool cleaner such as an Aquabug. If you have a slimline skimmer there is a port located just below the skimmer door it is used for the vac hose. After connecting the hose you put your skimmer lid down inside of skimmer and then you can turn on pump. By doing it this way you can let skimmer basket catch all large debries. This saves on having to backwash so much.
You can buy a devise called a Jeanie Jet and it connects to your water hose. Take the lid off your pump and insert it into the front of the pump going back to the skimmer. You then turn on the water and it should blow out the line and unclog it. What comes out of that line will come out into the skimmer so watch for it.
To fix a clogged brake line, first find the clog. Then, remove the clogged line from the cylinder. Attach a new line, and pump the car's brake to test it before driving.
You cannot clean it. If it is clogged it must be replaced.
A protein skimmer uses small bubbles to trap proteins. The bubbles then form foam at the top of the water which can then be removed make the resulting water clean.
you may have to prime your pump Clean or replace the filter.
The easiest, and cheapest way is to turn the suction valves off to everything but the suspected skimmer, if your pump bowl stays full of water, it is fine, if it automatically looses suction, then you have either a break or a blockage. Put a plumbers helper in the suction side of your pump pot and blow whatever blockage you have towards the skimmer. A snake will not work here because your skimmer actually has vacuum (negative) pressure unlike a sewer line,which is not a pressurized line. tritonunderwater.com
A clogged air conditioner drain line can cause water leakage.
Is the clogged water line causing any problems in your plumbing system?