I filled my 18'x44" above ground pool with well water by running the hose for two hours, turning it off for 1 hour, then running it again for two hours, etc. It took from Thursday afternoon until Monday afternoon to complete. I did not do it during the night hours (8 p.m. 'til 7 a.m.). My bigger concern was ruining my well pump. I didn't have any problems doing it this way. Good luck!
If you have a volunteer fire dept. nearby, sometimes they fill it for a small donation.To give you an idea, a 36-foot by 18-foot by 5-foot deep pool takes about 24,000 gallons of water to fill.
Yes, there is a 'water fill level' inside that you can't miss. Yes you can use it without water, but, only with the massage mode. DO NOT use heating mode without water. It will fry the heating elements.
They would be way too heavy if you fill them with water.
7.48 US gallons of water.
The pool holds 7,600 gallons of water
It's just a hole in the ground. You dig a hole a foot or so deep, go to the bathroom in it, and fill it in.
Depends on the depth of the pool
598 Imperial gallons, approx.
5300 gallons
One foot is 30.45cm if I am not mistaken. That is 3.45dm One liter of water fits in one cubic decimeter. The rest is up to you.
WolframAlpha, a new search engine gives a UK gallon of water at 0.1337 cu.ft so your pool should take 6,462 gallon to fill, give or take a cupful. Check it out!
It takes 108 tiles to fill a 3-foot by 4-foot rectangle how many tiles would it take to fill a 4-foot by 5-foot rectangle?