0
It really depends on the type of filter and pump arrangement you have.
Generally, a hose would connect from the skimmer of the pool ( the round box on the pool wall - most pools) to the suction side of the pump (the virtical part with the basket inside)(the one with the motor attached); then, from the outlet or discharge side (usually just above the motor) to the filter inlet. From the filter outlet back to the pool return wall fitting or eyeball.
k
What else can I help you with?
How do you hook up saltwater pump to an intex pool?
how do you hook up the cleaner to salt water pool pump
How can I properly hook up a pool pump?
To properly hook up a pool pump, first, make sure the pump is placed on a level surface near the pool. Connect the pump to the pool's filtration system using the appropriate hoses and fittings. Ensure the pump is securely connected to a power source and follow the manufacturer's instructions for priming and starting the pump. Regularly check and maintain the pump to ensure proper functioning.
How do I properly hook up a pool pump?
To properly hook up a pool pump, first, make sure the pump is placed on a level surface near the pool. Connect the pump to the pool's filter system using the appropriate hoses and fittings. Ensure the pump is securely connected and the hoses are tight to prevent leaks. Finally, prime the pump by filling it with water before turning it on to ensure proper operation.
Can you swim in a pool while you are filling it while the pump hook up?
I don't see why you couldn't.
Can you hook up two pool filters back-to-back to increase efficiency?
Wouldn't it be better to simply buy ONE more efficient pump rather than having two? My neighbor does have one pump for the automatic vacuum and one pump for general filtering. He did, however, have these put in when the pool was installed.
Is it normal for the pool pump to fill up with water while the pool is still filling up?
Certainly, if the pump is running. The primary pump intake is the main drain at the deepest part of the pool.
Where do I hook the pool vaccine to?
To properly hook up a pool vaccine, typically referred to as a pool sanitizing system or chlorinator, you should connect it to the circulation system of your pool. This often involves integrating it into the plumbing lines after the pump and before the pool returns. Make sure to follow the manufacturer's instructions for installation, ensuring proper placement and flow direction for optimal disinfection. If unsure, consulting a pool professional can provide guidance specific to your setup.
How do you backwash by cleaning a pool without a pump?
You can set up a siphon hose if your pool is on a hill, otherwise, buy a pump. Hatawa
How can you make a one and a quarter inch inlet and outlet on an intex pool two inches so you can hook up a regular pool pump and filter?
Yes. If it's PVC, just go to the local HW store and buy the adapter components required, primer and glue. The pressure will be fine, what do you have to lose to try it assuming you already have the pump?
What is the function of a pool pump start capacitor and how does it contribute to the operation of a pool pump?
A pool pump start capacitor helps the pool pump to start up quickly and efficiently by providing an extra jolt of electricity. It stores and releases energy to help the motor overcome the initial resistance when starting, which helps prevent damage to the motor and ensures smooth operation of the pool pump.
How do you heat a cheap intex pool?
With a solar blanket . They also have solar heaters you can hook up to them.
Swimming pool pump that works fine However when you hook up the vacuum to it it loses its pressure and suction Is it that the pump is just to old?
Possible causes: holes, cracks in vac hose - bad lid o-ring on pump - pump seal leaking - cracked pump lid or housing - pump basket full of debris - cracked or broken plumbing between the pump and the skimmer/vac hose connector.
