1. press mode (SP mode ON)
2. press mode (AL mode ON)
3. press start/stop (chime on & alarm off)
4. press start/stop (chime off & alarm off)
5. press start/stop (chime off & alarm on)
6. press start/stop (chime off & alarm off)
7. press mode (basic watch mode)
Close the door.
1997olds 88 the brake chime will not shut off where is the sensor so i can disengage it
remove fuse
Wear your seatbelt.
To turn off the hour chime on a Marea watch, locate the mode button on the side of the watch. Press and hold this button until you enter the settings mode, then navigate to the chime or alarm setting. Once you find the hour chime option, set it to 'off' or 'disable,' and confirm your selection. Finally, exit the settings mode to save your changes.
To shut off the door chime on a 2004 Kia Optima, you can try the following steps: First, ensure all doors are closed properly, as the chime often sounds when doors are ajar. If the chime continues, locate the fuse box under the dashboard or in the engine compartment and remove the fuse related to the door chime or instrument cluster. Alternatively, consult your owner's manual for specific instructions or settings related to the chime.
If you connect you seatbelt for about a minute or two, then take it off, it should shut off.
Ah, turning off the chime and alarm on your Cardinal digital watch is as simple as painting a happy little tree. Just locate the mode button on your watch and press it until you reach the alarm or chime setting. Once there, you can turn them off by pressing the adjust button. Remember, there are no mistakes, just happy little accidents.
In alarm mode, press the ADJ button and observe the lower left corner of the watch face The watch will cycle through alarm, alarm-chime, chime and all off?
Hit it with a hammer.
Hold down the reset button and then press the mode button to either turn the chime on or off. Indicator lights should go off/on around days of week.
You will hear a chime if you do not secure your seat belt in a Dodge Neon 1997. You ?æwill hear the chime once more after you turn off the engine, to let you know that you have completed the programming successfully.?æ