To determine how much sand is needed for a 10,000-gallon pool, it depends on the type of pool and the depth of the sand layer desired. For a standard sand filter, you typically need about 1 pound of sand for every gallon of water, translating to roughly 10,000 pounds or about 5 tons of sand. However, if you're referring to a sand base for an above-ground pool, you'll need about 2-3 inches of sand, which would require around 1-2 tons of sand, depending on the pool's dimensions.
130000 btu
You must work out the fraction (size of your pool)/(size of pool on the chemical container) if it is given. If your pool is 2,600 galls and the amount of chemical is given for a 10,000 gall pool, you need 2600/10000 of the amount, ie 26/100, so for every 100 grams recommended, put in 26.
Not hurt the pool but it can inhibit chlorine from sanitizing properly in high amounts. If its to high just drain some water out and refill with fresh.
Generally, you would need about 2-3 pounds of chlorine for a 1000 gallon pool to properly sanitize it. It's important to follow the manufacturer's instructions and recommended dosage for the specific type of chlorine you are using.
you can back wash the pool and drain to proper level Throw a pool party with lots of energetic kids.
I think the best one out there is "The Pool Cleaner" by Poolvernuegen.
For a 4500 gallon pool, you will need about 1 gallon of liquid chlorine to raise the chlorine level by 1 ppm. The amount of liquid chlorine required will depend on the current chlorine level in the pool and your desired level.
Approximately 200 lbs.
about 3 oz.
It would take a significant amount of Jell-o or gelatin to fill a 300-gallon pool, likely more than is practical or feasible. A more suitable option would be to use water or another liquid.
a 462000-gallon boiler, unlikely to be found on the market :)
You should use about 15oz. if bleach to reach between 1.5-3.5ppm chlorine.Hope this helpRobert