Check voltage at terminals in motor. 230v- 2 hot legs? Shut off power.
Verify shaft turns by rotating by hand.
Check continuity to switch contacts and to start capacitor.
Short out then test start capacitor.
Start switch on motor can have dirty or pitted points. You can file them smooth with a very small file. Verify switch opens completely when centrifugal weight swings by operating it by hand. Are points still stuck together? Do they come back into full contact when switch is let go?
Hayward uses AO Smith motors. You didn't mention single or 2 speed, voltage, or symptoms of your problem. I could walk you through any issues with it at all, but alot of it is available on line under 'AO Smith motor troubleshooting'.
Good luck.
A: Checking continuity is the same as checking resistance, therefore yes someone can determine the resistance at that particular current level
we can use ammeter for current checking
To determine your current health insurance coverage, you can check your insurance card, review your policy documents, or contact your insurance provider directly for details on your plan.
The driver is checking the current speed of the vehicle, as indicated by the speedometer.
To determine if you have health insurance, check your insurance card or policy documents for details about your coverage. You can also contact your insurance provider directly to inquire about your current health insurance status and coverage.
You need to either contact your agent, a registered rep, or the insurance company directly and ask them for a current illustration.
No, you cannot sail directly to another country from your current location.
To determine if Playland is open on May 30, it's best to check their official website or contact them directly, as operating hours can vary each year and may be affected by weather or special events. Typically, amusement parks like Playland have specific opening dates for the season, so checking for the most current information is essential.
the collector current is directly proportional to the base current
The factors that determine the amount of induced current in a coil include the rate of change of magnetic flux through the coil, the number of turns in the coil, and the resistance of the coil. Faraday's law states that the induced electromotive force (emf) is directly proportional to the rate of change of magnetic flux.
To determine a company's current ratio, divide its current assets by its current liabilities. This ratio helps assess the company's ability to cover its short-term debts with its current assets.
I'm sorry, but I cannot provide real-time information or current addresses for specific businesses, including Ekco Prudential cookware. I recommend checking the company's official website or contacting them directly for the most accurate and up-to-date information.