answersLogoWhite

0

Yes, you should run your pump while using a clarifier. Keeping the pump on helps circulate the water, allowing the clarifier to effectively bind with particles and improve filtration. This circulation ensures that the clarifying agents can reach all areas of the pool, enhancing their effectiveness in clearing cloudy water. Make sure to run the pump for the recommended duration as specified by the clarifier's instructions.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

What should I do if my pool is cloudy?

If your pool is cloudy, you should first test the water to check the pH and chlorine levels. Adjust them if needed. Then, clean the pool filter and skim the surface to remove debris. Consider using a clarifier or flocculant to help clear the water. Lastly, run the pump and filter system regularly until the water clears up.


Replaced the pump in my above ground pool as it wasn't pushing out enough pressure for the vacuum now I have thick looking stuff at the bottom I don't think the auto vacuum will be able to move it.?

Have you used clarifier or flculent at any stage to clear the pool water. If you have the thick looking stuff is the clarifier or floculant settled on the bottom. The pool pump will pump this stuff only it is important not to put it through the filter as it will block it up in no time. Gently hand vacuum it to waste.


Should the fule pump continue to run while you drive?

Your fuel pump should ALWAYS run while you drive, because it's electric and if the fuel pump wasn't running the gas wouldn't move through the car.


Do you leave filter pump on while shocking your pool or?

Yes, you should run the pump when you add chemicals to your water,


Where should you snoot the rooster using a bb pump gun?

head shot


Is it true that you can get more milk using a manual pump compared to an electric pump"?

While some people may find they can express more milk using a manual pump compared to an electric pump, this can vary depending on individual preferences and comfort levels. It is important to choose a pump that works best for you and your needs.


What if your breast pump had mildew in it should you throw away the milk that you pumped with it?

Yes you should throw away the contaminated milk and sanitize the pump according to the manufacturer's instruction before using it again.


Where is the fuel pump on geo metro?

The fuel pump is in the gas tank. While you are in there, you should replace the screen that is on the suction side of the pump. Also, the fuel filter is just outside the tank and should be replaced. Mr Geo Metro leehduncan@verizon.net


Do you have a engine surge while driving after installation of new fuel pump in a 2000 Chevy Malibu?

No, there should not normally be any engine surging while driving following installation of a new fuel pump.


You used 32 ounces of clarifier to your 30 round above ground pool for cloudiness The pool still looks cloudy what do you do?

If you are running the pump and filter for a few short hours it will never clear up no matter how much clarifier you add. Clean the filter first then run the pump for 24/7 until you can see and read a quarter at the main drain of your pool ~ or the deep end if you have no M/D. Adjust the chemicals as needed and follow allthe instructions on the clarifier bottle. Chlorine needs to be at of above3.5 to 5.0 or higher. pH at 7.6; Alkalinity at 80 - 120. k


How do you turn milky water back to sparkling clear?

Try hitting it with a clarifier, your pool shop will have it in stock. First hit it with an algaecide then cast a clarifier over the surface of the pool and let it rest without the pump going for at least a full 24 hours. At that time you will notice that the pool water is clear except a layer at the bottom, carefully vacuum this layer out to waste, do not put it through the filter


When should you change the timing belt on a 2003 Toyota Sienna?

90,000 miles. You should probably chenge the water pump while your at it.