answersLogoWhite

0

A backflush is a temporary reversal of the flow of fluid, especially of liquid through a membrane.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How we can differentiate traditional costing from backflush costing?

in backflush accounting the inveniery is not hold.work in process is not involved


Example for backflush costing and target costing?

for backflush costing and target costing?" Refer this link www.iugaza.edu.ps/users/shelles/Horngren/ch14.ppt


What is backflush?

to redirect flow in opposite direction of normal flow


How do you use peak backflush kit?

To use a Peak backflush kit, first ensure your espresso machine is turned off and cooled down. Remove the portafilter from the group head and insert the backflush disk or blind filter along with the backflush detergent. Lock the portafilter back into the machine and run the brew cycle for about 10-15 seconds, then stop it, and repeat this process several times. Finally, remove the portafilter, rinse it thoroughly, and run a few cycles with just water to clear out any remaining detergent.


What is backflush costing?

Usualy a back flush takes about 75mm (3") from the water level.


What if you have antifreeze but car still produces no heat?

Bad or clogged heater core. Backflush it.


How do you back-flush a 2001 Ford Expedition?

How to Backflush Cooling Systems Check related link below.


What do you use to clean an espresso machine?

The cleaning agent is sometimes referred to as a backflush detergent such as Cafiza, Purocal, or JoeGlo,


After drawing blood from an indwelling catheter the line is cleared of the what?

After drawing blood from an indwelling catheter, the line is cleared of the backflush. In some cases, the patient can be taught to clear the line by himself or herself.


Your 1990 ford ranger has little heat?

One of these things is the cause. Thermostat stuck open, replace it. Heater core stopped up, backflush the hearter core, and service the cooling system. Heater temperature control valve defective, replace it.


How do you back flush your cooling system on your 1997 grand-am?

to do ANY back flush you will need to go to the autoparts store and get a backflush kit, they are inexpensive, but it is well worth it, now if you look at your firewall (the wall between your engine compartment and the interior) there will be two hoses coming out in close proximity to each other. usually near the center or like on my 2001 grand am closer to the drivers side. those are your heater inlet and outlet, the one you are looking for is the heater inlet, it runs from the firewall to the top of the engine, the outlet runs to the water pump you will then need to follow the directions on the specific backflush kit you purchased, but it will always be on the heater INLET hose. hope this helped


How do you know your heater core is bad?

1. windows fog up for no apparent reason heater not blowing hot disconnect hoses going to heater core. use garden hose to check flow. if not much flow backflush see if it unclogs. car runs a little hotter than normal.