0
The gell coat is oxidizing or mineral deposits are building up. Find an approved method of polishing the gel coat that will remove oxidization and mineral buildup. If the white stuff is under the surface of the water your alkalinity may be unbalanced. If you have a D.E. filter you may have a small leak. You should brush the pool and make sure the filter you are using is working properly vacuuming will also help.
3rd answer:
I believe the first answer would be the better one. The second would be unlikely based upon the entire question above.
K
What else can I help you with?
Is fiberglass brittle or ductile?
Depends on the fiberglass and how it's been made up- I build model boats with fiberglass hulls that can be flexed about to a certain extent, but too far and it'll just snap Hope this helps -Dan
What materials are used to build ships?
steel aluminium fiberglass fuel water dust
What is the best material to build a RC controlled submarine?
Fiberglass would be the only material for R/C submarines.
Can the materials used to build a car affect vehicle speed?
Yes. If you make it out of plastic or fiberglass it will reach higher speeds then if it was made out of metal
How should I hold my fingers on the guitar to play effectively?
To play the guitar effectively, place your fingers on the frets with the tips of your fingers, not flat. Keep your fingers close to the frets for clear notes and use the correct finger placement for each chord or note. Practice regularly to build strength and dexterity in your fingers.
Im 12 years old and my fingers are so chubby how do i loose it?
Try using stress balls. It's relatively cheap and helps build muscle around the fingers.
What are other choices if you are not able to get financed for a fiberglass pool?
there are aluminum pools, steel pools if they are above ground and they also have cement in ground pools that they build in your yard.
How do you mold a body kit to a car with fiberglass?
Since most of the time the body kit bolts on but does not fit correctly you must make it fit. Most people use fiberglass and build up the areas that need to be filled. Once you build it up so that there are no gaps in the seams or very little gap then your done. You must get fiberglass sheet resin and hardener after applying let it dry and sand. if you dont sand and add on top of an uneven surface it will build up uneven the dry time depends on the temp and how much hardener is applied i usually just let it dry overnight since i work at night.
Why do my fingers hurt when playing the guitar?
When playing the guitar, your fingers may hurt because of the pressure and friction from pressing down on the strings, which can cause irritation and soreness in the fingertips. Over time, as you build calluses and strengthen your fingers, the pain should decrease.
How can I improve my technique for fretting a guitar?
To improve your technique for fretting a guitar, focus on placing your fingers close to the fret wire, using the tips of your fingers, applying just enough pressure to produce a clear sound, and keeping your fingers arched and relaxed. Practice regularly to build strength and dexterity in your fingers.
In the book hoot did they still build the mother paula?
No they did not because Roy, Beatrice, and Mullet Fingers stop the construction of it.
What materials are used for a houseboat?
A houseboat is a kind of a boat that has been modified to become a house. Some materials used in order to build a houseboat are fiberglass, steel, wood and aluminum.
