0
What else can I help you with?
Can anyone provide me with Aquaslide Queen installation directions I bought a slide but it's not together and some of the legshardware is missing?
Google Aquaslide parts. k
How can you repair cracks and clean the gel coat on AquaSlide N Dive brand fiberglass slides?
Check with a boat company. They have many product to repair fiberglass. Oh boy, I wouldn't want my kids sliding down an old , repaired slide with a possibility of getting a fiberglass chip or sliver rammed into their leg, hand, arm or butt and possible removing a good chunk of skin. No indeed. Too much liability. Even a new slide is a liability. For the cost of materials and your labor( what is your time worth) consider if you will ordering a replacement chute. I would inspect the stand's leg supports anchors, water feed, ladder, grab rails and other parts for soundness before ordering replacement. k
Do you offer slide door screen replacement services?
Yes, we offer slide door screen replacement services.
Are parts for Aquaslide still being manufactured if so where can I buy a whole kit support system since I only have the fiberglass slide part left?
Try this link http://www.poolcenter.com/parts_deck_equipment_aquaslide_n_dive_slide_parts.htm
Where can you find parts for a aqua slide n dive diving board specifically the 4-5 inch bolts that go through the back of the board into the spring base. I think they are half inch bolts?
We found the bolts in the local Home Depot. But, we need to replace our Aquaslide N Dive diving board. Does anyone know where we can find a replacement board?
What happens if the slide ladder does not work for the GCF and LCM?
you have to use a factor tree
A ladder is leaning against a wall if you were going to climb the ladder are you better off if there is no friction between the ladder and the wall or ladder and the floor?
No. if the floor is smooth you must have friction between the ladder and the floor, or the ladder would just slide away. Technically you could do without friction between wall and ladder, but even that can be helpful in preventing the ladder from going sideways.
Is ladder leaning with wall in equilibrium?
No, a ladder leaning against a wall is not in equilibrium. Equilibrium would occur if the forces acting on the ladder were balanced, but in reality, the ladder is subject to gravitational force and may slide or topple over if not properly stabilized.
What simple machine do you use to get up a slide?
a small crane made of pulleies and rope
How do you Clear the ice to get to the ladder in FireRed?
Step on the ice and slide across the big sheet like a skating rink to get to the ladder use the rocks to help you change direction.
If you had a slide 3 meters long at an angle of 40 degrees how high will the ladder need to be?
Is this a vertical ladder? Another contributor's answer:Providing that the slide is on level ground and that the ladder is vertical then you have the outline of a right angle triangle with an hypotenuse (the slide) of 3 metres and an adjacent angle of 40 degrees. To find the height of the opposite (the ladder) side of the triangle use the trigonometrical sine ratio: sine = opposite/hypotenuse When the ratio is rearranged: opposite = hypotenuse*sine opposite = 3*sine 40 degrees = 1.928362829 metres So the height of the ladder needs to be nearly 2 metres high.
Which type of ladder consists of two or more sections that travel in guides or brackets?
An extension ladder consists of two or more sections that can slide in guides or brackets to extend the length. This type of ladder is adjustable and typically used for reaching higher places, such as rooftops or tree branches.
