It goes into the main sewer system. It will go through your sewer system and then out to the main sewer. That is if you live in town!
my washer keep on by passing the spin cycle and will not drain out the water.
To get water to it, and to have it drain
The drain hose on a washer is typically located at the back of the machine near the bottom. It is usually connected to the drain pump and is used to remove water from the washer during the draining cycle.
To drain a Maytag washer, locate the drain hose at the back of the machine. Position the hose over a drain or bucket, then remove the plug or clamp to release the water. Allow the water to drain completely before replacing the plug or clamp.
The drain from the washer to the main line is getting plugged and the floor drain is easier. Drain cleaner in the floor drain should take care of it.
To replace the washer drain hose, first unplug the washer and turn off the water supply. Locate the hose at the back of the washer and disconnect it from the drain pipe. Install the new hose by connecting it to the drain pipe and securing it in place. Test the washer to ensure the new hose is working properly.
To install a washer drain pan properly, follow these steps: Measure the space where the washer will sit and choose a drain pan that fits. Place the drain pan in the designated area, ensuring it is level. Connect the drain pan to the existing plumbing using the appropriate fittings. Test the drain pan by running water through the washer to check for leaks. Secure the drain pan in place to prevent movement. By following these steps, you can install a washer drain pan properly to protect your floors from potential water damage.
To properly install a washer drain hose, first ensure it is the correct length and diameter for your washer and drain pipe. Attach one end of the hose to the washer's drain outlet and secure it with a hose clamp. Then, insert the other end into the drain pipe, making sure it is secured in place. Test the washer to ensure there are no leaks and that the water drains properly.
To properly perform a washer drain hose replacement, first unplug the washer and turn off the water supply. Remove the old hose by disconnecting it from the washer and the drain pipe. Install the new hose by connecting it securely to both the washer and the drain pipe. Make sure the hose is not kinked or twisted. Test the washer to ensure there are no leaks before using it again.
A drain pan for a washer is used to catch any water that may leak from the machine. It helps prevent water damage by containing the water and directing it to a drain, rather than allowing it to spread and potentially damage the surrounding area.
Simple, there is somthing clogging you drain or YOUR WASHERS BROKEN GET A NEW ONE
Kitchen sink and washer use same drain line. Drain line clogged causing backup of drainage from washer into kitchen sink. Have drain line unclogged to take care of problem. If drain line not clogged, check for proper venting of drain lines.