answersLogoWhite

0

I have a salt water system and recently had my pool resurfaced. There was no staining. If you put your salt in the skimmer like you we're supposed to there should be no staining, If you put your salt directly into your pool it could stain from the minerals in the salt. If you used table salt there will be much less staining than if you used road salt.

ANSWER::

You should NEVER use road salt or table salt. Wrong chemical make up! Follow directions on the "pool salt" bag. The salt goes into the pool and not the skimmer!! You must brush any salt that lingers on the floor until it is mostly dissolved. DO NOT add salt until the water has filtered for at least 24 to 36 hrs. or that recommended by the manufacturer or pool builder. Do not rely on other people to tell you what needs to be done. GO to the source -- builder - manufacturer. You should not have staining if the above basics are followed. Additionally, you must run the standard pool equipment for about 2 weeks or more. This gives the plaster time to cure properly. The salt system can and most likely be installed by the builder as he installs the pump and filter. The salt system unit will not be turned on until the plaster has cured. After the cure you must follow procedures on the proper start-up of the salt system.

K

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What problem does over filling transmission cause?

It can cause seals to leak if you overfilled it. Drain the excess fluid out immediately, before you ever start the engine.


What are the best techniques for installing an oak crown mold in a room?

The best techniques for installing an oak crown mold in a room include measuring and cutting the mold precisely, using a nail gun or adhesive to secure it to the wall and ceiling, and filling any gaps or seams with caulk for a seamless finish.


What are the best techniques for installing cabinet crown moulding?

The best techniques for installing cabinet crown moulding include measuring and cutting accurately, using a coping saw for inside corners, securing the moulding with finishing nails, and filling any gaps with wood filler or caulk for a seamless finish.


Can we see cytoplasm in a light microscope?

Yes, the cytoplasm can be seen in a light microscope as it appears as a dense, granular material filling the interior of a cell. It is not visible when cells are stained properly.


What are the best techniques for installing crown molding trim in a room?

The best techniques for installing crown molding trim in a room include measuring and cutting the molding accurately, using a miter saw for angled cuts, securing the molding with nails or adhesive, and filling any gaps with caulk for a seamless finish.


What is a iron filling?

Iron filling is a filling which can be made by iron filling


What are the best techniques for installing floor trim in a room?

The best techniques for installing floor trim in a room include measuring and cutting the trim accurately, using a miter saw for angled cuts, securing the trim with finishing nails or adhesive, and filling any gaps with caulk or wood filler for a seamless finish.


What are the best techniques for installing floorboard trim in a room?

The best techniques for installing floorboard trim in a room include measuring and cutting the trim accurately, using a miter saw for angled cuts, securing the trim with finishing nails or adhesive, and filling any gaps with caulk or wood filler for a seamless finish.


How are sinkholes fixed and what methods are commonly used to repair them?

Sinkholes are typically fixed by filling them with a combination of materials such as concrete, grout, or soil. Common methods used to repair sinkholes include injecting grout to stabilize the ground, excavating the area and filling it with a stable material, or installing support structures to prevent further collapse.


What are the best techniques for installing floor board trim in a room?

The best techniques for installing floor board trim in a room include measuring and cutting the trim accurately, using a miter saw for angled cuts, securing the trim with finishing nails or adhesive, and filling any gaps with caulk or wood filler for a seamless finish.


Why would someone have diahareah and be passing bright red blood filling toilet?

This is symptomatic of a serious, possibly life-threatening, condition and this person needs to seek medical attention immediately.


List all area of filling techniques?

boundary filling and flood filling