MY inground spa jets are not plugged. You could have asked the question: MY spa jets are plugged or seemed to have stopped functioning what is the cause?
Try cleaning your filter. Try emptying your pump or skimmer baskets. k
I have an inground spa when I turn on the jets they start then stop. I have put pressure in the line nothing clean the filter nothing. What can I do
Check with Edgewater Spa's 4000 Cherry Avenue, Long Beach, CA- (562) 434-1770
no but when the jets are the spa warms up faster It doesn't actually heat up faster with them on. The jets help circulate the water so that the temperature of the water throughout the spa will more quickly be even. If your spa is properly designed the jets shouldn't matter at all, in fact, since jets use outside air to cause the bubbles if the outside air is colder than what you heat it too (100+ degrees) then the jets will actually cool the spa down more quickly.
use something called soda ash you can find it at a pool or spa store
You can buy spa supply items at Oklahoma City Inground Pool Builder. You can reach them at their website at: www.pleasantpools.com.
You can try Fiesta pool and spa, its in your area. http://www.fiestapoolspa.com/
A spa is usually a description any kind of relaxation activity involving water. A hot tub can be considered a kind of spa that has hot water jets. http://www.goshf.com/hot_tub_jacuzzi_whirlpool_differences.htm
Yes, it is recommended to have a GFCI (ground fault circuit interrupter) protection for a spa even if it is being plugged into a GFCI circuit. This redundancy provides an extra layer of safety in case of any issues with the existing circuit.
It's tough to make a spa/hot tub with jets, but an above ground type pool is not hard. The fiberglass on a spa is the hard part, but if you could get that & pump system, decking can all be built with some help from a carpenter.
It sounds like it may be the pipe that the back wash water comes out of when the filter is on back wash. A: The above is wrong. That pipe is for air suction to the spa jets thus giving the "Jacuzzi" action or aeration at the spa jets. k
usually it is caused by bad gas causing issues in the carb. a plugged filter or jets in the carb
the ejecter is bad ,itis ontop of the hoseing on clip and it will pop out,