it does work for round or hunched over backs
A Xerox machine works by using a combination of light, static electricity, and toner to create an image of the original document on a photosensitive drum. The drum then transfers the toner onto a piece of paper which is then fused using heat and pressure to create a copy of the original document.
you hit your bum violently on a drum. no specific drum is required.
hit it
you have to get a drum machine, or music software (like GarageBand). Some electric keyboards have drum kits as well. To record and save your work, the easiest way is to connect your equipment to a computer and record it. there's more to it, but that's the basic formula.
A front load washing machine works by filling the drum with water and detergent, then rotating the drum to agitate the clothes and clean them. The drum spins at a high speed during the rinse cycle to remove excess water from the clothes. Finally, the machine uses a drain pump to expel the dirty water and a spin cycle to extract more water before the cycle is complete.
The paper rotates on a drum under the pen while the pen moves across the drum.
A washing machine works by filling the drum with water, adding detergent, agitating the clothes to remove dirt, draining the dirty water, spinning the drum to remove excess water, and finally rinsing the clothes with clean water. The combination of water, detergent, and mechanical action helps to clean the clothes effectively.
Better off purchasing a new master cylinder or a re-manufactured. They are not expensive and all the machine work is done.
repelsteeltje
As a milling machine uses round cutters, misalignment of the head would leave the base of a key way or a machined surface concave.
The work done by a machine is the output energy provided by the machine in an intended task, while the work done on a machine is the input energy required to operate the machine. The work done by the machine should ideally be greater than the work done on the machine to ensure efficiency.