First, clear the shotgun and make sure it is completely unloaded. Open the action halfway and unscrew the takedown screw. Pull the barrel forward and remove. Push the trigger housing pin out of the shotgun and pull down the rear trigger guard. Remove the cartridge stop and cartridge interrupter. Pull the bolt slide out of the bottom of the receiver. Push the forearm grip forward and off the gun. Push the bolt out of the hole where the barrel was. Move the elevator out of the bottom of the receiver and you are finished.
Burn it!
Seperate it into smaller pieces
Should be the same as Winchester 1400 shotgun. Email me for a copy of the manual.
If you do not have a manual, you need to visit a gunsmith.
Seek the services of a good gunsmith
Shoot it about 2000 times without cleaning it. It will break down!!
NO. This could break down your grooves.
To clean a Western Field 12 gauge pump shotgun M550AD, first ensure the firearm is unloaded. Disassemble the shotgun by removing the forend and barrel from the receiver, following the manufacturer's instructions. Use a cleaning rod and appropriate brush to clean the barrel, followed by a patch soaked in gun solvent to remove any residue. Wipe down the receiver and other parts with a clean cloth, lubricate moving parts with gun oil, and reassemble the shotgun.
Try to pull it back. DO NOT LET IT SLIP OUT OF YOUR CONTROL!!!!!!!!!!!! If it doesn't move, take it to a gunsmith.
Impossible to answer since you don't provide the type of action (OU, SxS, Pump, Semi-Auto)
Send me your email & I'll send you a copy of the original manual.
they break down the oil into microscopic pieces and eat them