answersLogoWhite

0

JUST UNSCREW THAT HUGE NUT ABOVE THE HEAD IT WILL COME OFF....(

dONT HAVE IT RUNNING WHILE YOU DO THIS)

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you open the weed wacker head for maintenance or replacement?

To open the weed wacker head for maintenance or replacement, first make sure the tool is turned off and disconnected from power. Then, locate the screws or bolts on the head of the weed wacker and use the appropriate tool to loosen and remove them. Once the screws are removed, carefully lift off the head to access the inner components for maintenance or replacement.


How do you say weed wacker in Hebrew?

weed wacker = ויד וואקר (veed vahker)


How do you adjust carburetor on weed eater featherlite sst25?

The carburetor on a Weed Eater Featherlite SST25 is adjusted by turning the screws on the side of the carburetor. They control the idle mixture and idle speed of the engine.


What is the name of the part that has the string in it on a gas weed wacker?

what is the part of the weed wacker that has the string on it connected to the frane


Where can you buy a 4 cylinder weed wacker?

you wont find a 4 cylinder weed wacker ( too heavy ) but most lawn and garden dealers will carry a 4 stroke weed wacker.


How can I restring a Ryobi weed wacker?

To restring a Ryobi weed wacker, first, remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert one end of the line into the hole in the spool and wind it in the direction indicated on the spool until it is full. Reattach the spool to the trimmer head and feed the line through the eyelets. Your Ryobi weed wacker is now restrung and ready to use.


How do I restring a Ryobi weed wacker?

To restring a Ryobi weed wacker, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert the line into the spool following the arrows for direction. Wind the line evenly and tightly around the spool. Reattach the spool to the trimmer head and feed the line through the eyelets. Your Ryobi weed wacker is now restrung and ready to use.


How do you change the weed wacker string?

To change the weed wacker string, first, turn off the weed wacker and disconnect the spark plug. Then, remove the spool housing and take out the old string. Insert the new string following the manufacturer's instructions, and reassemble the spool housing. Finally, reconnect the spark plug and test the weed wacker.


Parts Manual Craftsman Weed Wacker?

What is the bottom cover on a weed wacker called? The bottom plastic part where the string is. just the plate


What to do went the thread on the toro weed wacker that holds the spool is strip.?

Replace the head or redrill the hole and retap it for a bigger screw.


Does a eager beaver weed wacker have a carburetor?

yes


How do you move the sail in steamworks?

you use the weed wacker