There should be a headstamp identifying the manufacturer on the rear of the casing. Normally, the calibre of the round would also be printed here, but some manufacturer's do not do this. See related link.
When you shoot a bullet the bullet casing pos out through the ejector and that is where the bullet is and gunpowder to fire it.
Do you mean a cartridge casing or the actual bullet?? One used in combat or just a WW2 era casing??
The diameter of the bullet casing, measured at 7.3 mm, is 7.3 millimeters.
there is the primer, the rim, the casing and the projectile there is the primer, the rim, the casing and the projectile there is the primer, the rim, the casing and the projectile
there is the primer, the rim, the casing and the projectile there is the primer, the rim, the casing and the projectile there is the primer, the rim, the casing and the projectile
If you find a bullet casing, you should not touch it and immediately contact the authorities, such as the police, to report the discovery. It is important to leave the casing undisturbed to preserve any potential evidence.
Grab and pull/twist or use a kinetic bullet puller.
The same as it is before it's fired - a casing. Some refer to an empty casing as a "shell" or "shell casing".
The (shell) casing or the cartridge carries the actual bullet projectile.
During the loading or reloading process after the projectile is fitted to the casing the casing area that is holding the bullet ( the neck) is mechanically squeezed to provide a tight seal around the lead projectile.
I believe the smallest bullet in terms of diameter is the .17 HMR. It is a .22 casing that is necked down to accept a .17 caliber bullet.
An expended shell casing is the empty metal container left behind after a bullet is fired from a gun. It holds the primer, gunpowder, and projectile before being shot. Shell casings are often collected at crime scenes as evidence to help identify the type of weapon used.