1. Make sure the weapon is unloaded
2. Make sure the weapon is unloaded
3. Make sure the weapon is unloaded
4. Make sure the weapon is unloaded
5. Make sure the weapon is unloaded.
6. Open the bolt while holding the trigger to the rear, pull bolt out.
Remove the stock and you will see what is keeping the bolt from sliding out.
First remove the screw opposite the bolt. Operate the bolt as if you were cocking the gun, pull the trigger and it will slide out.
Actuate the bolt to the rear and there is a tang in front of the trigger that hangs down..Press up on this tang and pull the bolt back and it will remove it from the action.
this is a bolt action rifle
stevens bolt action 22 model 840
The Garand rifle is a semiauto, not a bolt action. Do you have a Model 1903A3 bolt action? A Model 1917 bolt action?
Move the safety forward to the 'fire' position, then open the bolt. As you are sliding the bolt to the open position, pulling the trigger will allow the bolt to be removed.
To remove the bolt action from a Western Auto Revelation .243, first ensure the firearm is unloaded and pointed in a safe direction. Open the bolt and locate the bolt release lever, typically found on the right side of the receiver. Depress the release while pulling the bolt rearward to completely remove it from the action. Always consult the owner's manual for specific instructions related to your model.
Model 58 is an automatic not a bolt action
To remove the bolt from a Model 30A, first ensure the firearm is unloaded and pointed in a safe direction. Open the action and locate the bolt release, typically found on the right side of the receiver. Press the bolt release while simultaneously pulling the bolt handle to the rear until it clears the receiver. Once fully retracted, the bolt can be removed from the receiver.
Your rifle was made by Savage for Western Auto. It is a Savage Model 46. You can contact Savage for an owners manual. It is a very basic bolt action. Remove the screw on the underside of the forearm to take action out of stock. Push the 2 pins out that hold the trigger group in place, and you can remove the bolt. gunpartscorp was a schematic at their website, under savage 46.
A model 1904 is a single shot bolt action rifle.