Remove all parts put receiver in a vice upside down with two pieces of leather on ether side to protect the receiver get something that will grip the barrel and give it slow steady pressure while watching the receiver to make sure you are not bending or warping it you have to put a good amount of force to brake the barrel loose but once you brake it loose you should be able to remove it buy hand hope this helped be careful not to bend your receiver. I used xl pipe rench
I have a Model 67h, The magazine holds 4 with one in the camber.
savage
A Savage Springfield 67H is worth between 100 and 200 dollars pending on condition.
Try e-gunparts.com
Never?
It was disc.in 1989
One site was selling one in "good condition"for $139.
On the left side of the reciever, right above the trigger
The Springfield series 67H was produced by Savage arms from 1958 to 1971.
The Springfield/Stevens model 67 shotgun dated from 1986-1989.
To disassemble a Springfield Model 67H shotgun, first ensure the firearm is unloaded and the chamber is clear. Begin by removing the fore-end by unscrewing the bolt that holds it in place. Next, take out the barrel by loosening the magazine tube and sliding the barrel forward. Finally, disassemble the receiver by removing the trigger assembly and any other components as needed, following the manufacturer's instructions or a detailed manual for specific steps. Always prioritize safety and consult a gunsmith if unsure.
These were made between 1986-1989.