0
COLD ENGINE STARTING OR STARTING AFTER REFUELING
--Set unit on a flat surface.
--Slowly press the primer bulb 6 times.
--Move choke lever to FULL CHOKE position.
--Squeeze the throttle trigger fully and hold through all remaining steps.
--Pull starter rope handle sharply 6 times.
--Move choke lever to HALF CHOKE position.
--Pull starter rope handle no more than 6 pulls, until engine runs.
--Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position.
RESTARTING A WARM ENGINE
--Move choke lever to OFF CHOKE position.
--Pull starter rope handle until engine runs.
--If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.
What else can I help you with?
How do you adjust carburetor on weed eater featherlite sst25?
The carburetor on a Weed Eater Featherlite SST25 is adjusted by turning the screws on the side of the carburetor. They control the idle mixture and idle speed of the engine.
How do you adjust carburetor on weed eater featherlite FL21?
by turning the screws on the side of the carburetor
What is the fuel mixture for the weed eater featherlite fl20?
3.2 ounces per gallon
What type of oil for featherlite weed eater?
2 cycle oil. You can purchase it from any home improvement store
Feather lite weed eater spark plug gap?
whats the sparkplug gap on a featherlite fl 25 weedeater
Is there a gas and oil mixture for the weed eater featherlite fl20?
The mixture is a 40:1 ratio, that's 3.2 oz of two cycle oil to 1 gallon of gas
Where can I get an owners and repair manual for weed-eater brand weed-eater type 1?
Weedeater products, or FeatherLite Weedeaters are made by Poulan. The web address in weedeater.com. There you will be able to put in the model number (ex. FL20), and select type 1. You will get an illustrated parts list and order any part you need.
What is the oil ratio for a weed eater featherlite FL1500i gas blower?
The Weed Eater Featherlite FL1500i gas blower typically uses a fuel mixture of 40:1, which means 40 parts gasoline to 1 part two-stroke oil. It's essential to use a quality two-stroke oil designed for air-cooled engines to ensure optimal performance. Always refer to the user manual for specific recommendations and guidelines for your model.
How do you adjust carburetor on weed eater featherlite FL25c?
To adjust the carburetor on a Weed Eater Featherlite FL25C, locate the three adjustment screws marked "L" (low speed), "H" (high speed), and "T" (idle). Start the engine and let it warm up, then adjust the "L" screw for smooth acceleration and the "H" screw for maximum power without causing the engine to sputter. Finally, adjust the "T" screw to achieve a steady idle. Always make small adjustments and test the engine after each change to find the optimal settings.
How much to repair a pull start on a weed eater?
10
Where do you rid old weed eater?
You can get rid of an old weed eater at a recycling center. If you take the weed eater apart, you can get money for the metal.
When was Mister Weed-Eater created?
Mister Weed-Eater was created in 1993.
