Here's the basics on mounting the scope on a rifle. ( Assuming you have a scope mount on the rifle.)
1. Place the bottom half of the scope rings on the rifle first (Without the scope attached.)
2. Place the scope on the bottom half of the rings and adjust the scope mounts to comfortably fit your eye. When adjusted, tighten down the bottom half of scope rings to the rifle mount. ( The scope should have one cross hair adjustment at the top and one on the right.)
3. Place the scope in the rings and then put the top half of the rings on. Tighten them down, but not VICE tight, just loose. You still want to move the scope some.
4. Look through the scope and align the cross hairs level with the rifle barrel. The Vertical line should be straight up and down at a right angle with the barrel.
5. when you have the scope adjusted to your eye and the barrel of the rifle, tighten the top scope rings in a crisscross pattern a little at a time. Don't vice one down then go to the next one. Do it a few turns on each one until they are tight.
A final note. If you have a small screw hole and screw at the back end of the scope mount (on the rifle) you may want to place the rear scope ring against that screw. This is a scope stop. This will keep the scope from moving back from the recoil. Some scope mounts have a long pad at the rear of the scope mount that acts the same way. It's usually necessary on high powered rifles not 22's.
Best left to a gunsmith
You need a good gunsmith
Yes. But it requires a special scope mount from Crosman. ( Crosman owns Benjamin and Sheridan ) ( see the link below )
buy a scope and scope mount, get an outer barrel sillencer extention, upgrade to a 6.03 milimeter tightbore barrel, and install a bipod.
The BSA Sweet 17 rifle scope is an affordable scope that's designed for beginning rifle users. Average prices on the scope range from $50.00 to $100.00 in most cases.
There are benefits to using a Swarovski rifle scope. Rifle scopes in general helps one aim at an object with higher precision. This rifle scope in general has a higher reuse rate so one won't have to change it as often.
Yes, you can mount a scope on a .38-55 rifle, but it largely depends on the specific model and design of the rifle. Many traditional lever-action rifles chambered in .38-55 may not come with factory scope mounting options, so you may need to use a gunsmith to install a scout scope or a rail system. Additionally, you can opt for mounts that attach to the receiver or utilize a forward-mounted scope for better balance and handling. Always ensure that the mounting method does not interfere with the rifle's operation or aesthetics.
Y not?
To sight in a rifle scope without shooting, you can use a bore sighting tool or a laser boresighter. These tools help align the scope with the rifle's bore, allowing you to adjust the scope's reticle without firing any shots.
The Burris Eliminator Laser Scope is the most expensive laser rifle scope in production. It costs about 950 to 1,000 dollars.
Only if the scope is designed for an air rifle. Because of the recoil being different on an air rifle than a firearms rifle. Air rifle scopes are made differently than firearms scopes. A firearms scope can break it's glass mounts if it is used on an air rifle.
Almost any air rifle scope will fit a Daisy. Check Walmart or a sporting goods store for a Daisy scope. But any air rifle scope should fit the dovetail mount that is on the rifle.