0
What else can I help you with?
What's it called when a person's name is two first names?
They have a double name or double-barrel first name.
What is a double barrel ten gauge built in 1898 worth?
First, you will need to know the manufacturer's name, the model or model number, the serial number and condition of the 10 gauge double barrel shotgun before a "worth", can be considered.
How do you tie a secure double barrel knot?
To tie a secure double barrel knot, first make a loop with the rope. Then pass the end of the rope through the loop twice. Pull both ends of the rope tight to secure the knot.
When were TB Janney double barrel ten gauge shot guns made?
Sometime in the first half of the 20th century.
What kind of ammo can you use in a Nitro-Hunter 12ga double barrel?
HAVE IT CHECKED OVER BY A GUNSMITH FIRST!!!!!!!!!!!! It is an old shotgun.
Who made double barrel shot gun 9101?
From a book: THE SHOT GUN & ITS USES By "East Sussex" (First published in London in 1914.) says on page 2: "About 1800, however, the double-barrel shot gun was taken up, if not introduced, by Joe Manton..."
Which barrel do you shoot first?
The choice of which barrel to shoot first depends on the type of firearm and the intended purpose. In double-barrel shotguns, for example, many shooters prefer to fire the top barrel first for quicker follow-up shots. In contrast, some handguns with multiple barrels may not have a specific preference, as it can be based on personal comfort or the type of ammunition loaded. Always refer to the manufacturer's guidelines for optimal performance.
Can either barrel on the stoeger 3000 be fired first?
No. The Stoeger 3000 has no barrel selector and always fires bottom barrel first.
How do you attach a forearm to Stevens 940e?
To attach a forearm to a Stevens 940E shotgun, first ensure the shotgun is unloaded and safe. Remove the barrel by unscrewing the barrel nut, then slide the forearm onto the magazine tube. Align the forearm with the barrel, reattach the barrel, and tighten the barrel nut securely to hold the forearm in place. Always double-check for proper fit and function after reassembly.
How do you disassemble JC Higgins model 1017 double barrel?
To disassemble the JC Higgins Model 1017 double barrel shotgun, first ensure the firearm is unloaded and the safety is engaged. Remove the forend by locating and loosening the screws that hold it in place, then gently slide it off the barrel. Next, remove the barrel assembly by unscrewing the hinge pin or the barrel latch, depending on the specific design, and carefully lift the barrels away from the receiver. Finally, you can access internal components by removing the stock, typically done by unscrewing the stock bolt at the rear of the receiver.
Which barrel do you fire first in a double barrel shotgun?
Usually you fire the right barrel first. It's choke is normally a little open giving a wider spread of shot. You fire the second barrel which is normally a tighter choke at a target farther away. This tighter spread will be concentrated but spread because of the long range assuring more pellets hitting the target. Firing the right barrel at a greater range might have the target escape by having the shot pass by without hitting it because the pellets are spread too far apart.
Where can you find information about a double barrel exposed hammer shotgun made in Lexington Kentucky in the late 1800s?
You would first need to provide all of the markings found on the gun.
