There is no single simple answer. Your manual, or a manual from Troybilt.com will give you some troubleshooting suggestions. I can detail a list of the most likely problems, but you are not likely to understand or be able to act upon the information without extensive step by step information. And, I don't even know which model and pump you have. Troybilt uses several different pump designs. Check the nozzle on the end of the wand to make sure it is not clogged. Check that your hose delivers a proper water flow. Most other problems require significant pump knowledge... the unloader can be stuck, the valves can be damaged or full of trash, the key-way could be sheared, the oil end could be "fried"..ie bad bearings, broke pistons or retainers. Seals are not usually the cause of a complete lack of pressure..especially if there is no leaking water.
How much pump oil goes into a Troy Bilt Pressure washer Model 020242
Nothing!
Nothing!
5 oz
The Troy-Bilt pressure washer model 020241 typically requires about 0.6 quarts (or 20 ounces) of pump oil. It's essential to use non-detergent oil specifically designed for pressure washer pumps. Always check the owner's manual for the most accurate specifications and recommendations for your specific model.
Some website says 30w non-detergent?
The Troy-Bilt pressure washer model 01902 typically requires about 0.5 quarts (16 ounces) of oil for its engine. It's important to use the recommended oil type, which is usually SAE 30 or 10W-30, depending on the operating conditions. Always consult the owner's manual for specific details and maintenance recommendations.
To find the o-ring diagram for the Troy-Bilt pressure washer model 01903, it's best to consult the user manual or the manufacturer's website for specific diagrams and part numbers. Many manufacturers provide downloadable manuals that include detailed diagrams for maintenance and repair. Additionally, you can check online retailers or forums dedicated to pressure washer repairs for helpful resources. If you need further assistance, consider contacting Troy-Bilt customer service directly.
The Troy-Bilt pressure washer model 020208 typically requires about 0.5 to 0.6 quarts (16 to 20 ounces) of pump oil. It's important to check the owner's manual for specific recommendations, as oil capacity can vary slightly based on the model. Always use the recommended type of oil for optimal performance and longevity of the pump.
To change the pump oil in a Troy-Bilt pressure washer model 020207, first, ensure the machine is turned off and disconnect the spark plug wire for safety. Locate the pump oil fill cap and remove it, then drain the old oil by tilting the pressure washer slightly to allow the oil to flow out. Once drained, refill the pump with new oil until it reaches the appropriate level, then securely replace the oil fill cap. Finally, reconnect the spark plug wire before using the pressure washer again.
To change the pump oil in a Troy-Bilt pressure washer with a GCV190 engine, first ensure the machine is off and cool. Locate the oil fill cap on the pump, remove it, and drain the old oil into a suitable container. Then, refill with new pump oil until it reaches the appropriate level, as indicated on the pump's dipstick or fill line. Finally, replace the oil fill cap securely before storing or using the pressure washer.
See link; the OEM part # is a 5.3 OZ. bottle http://www0.shopping.com/xPF-Briggs-Briggs-Stratton-Synthetic-Pressure-Washer-Pump-Oil-5-3-oz-190585GS