answersLogoWhite

0

Well, matters how cold you want to be....
If you don't want to freeze (literally) that would have to be 33 degrees.

It also matters if you have a temperature for your heater to go off at.
On my heater, it goes on it the temperature in the house goes below 67 degrees, but I live in CA.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What temperature should you set your thermostat in your home for the winter for it to be enviromentally friendly?

As low as you can live with


Should the thermostat be set and not turned off in summer and winter?

i dont know =D


Where should you set your thermostat?

I would set it at 73 degrees both for summer and winter.. if you constantly turning it up and down it will make your electric bill go up..


Fridge thermostat on a fridgerator?

what should it be set at


If you have an electronic thermostat what should your temperature swing be set at?

TWO DEGREES


What would you set your home thermostat at during vacation in summer?

personally, from experience, i set mine at 55 over the winter. if u have any pets, i would set it around 60-70...but it depends


When should a thermostat kick on to regulate the temperature in a room?

A thermostat should kick on when the temperature in a room goes above or below the set temperature to regulate and maintain the desired temperature.


What temperature should you set your thermostat?

68-70f is adequate for most people.


What is a sentence for thermostat?

I set the thermostat for 70 degrees.


How can you test thermostat in your furnace?

Set thermostat to desired temperature; lets say, 70 degrees Fahrenheit, a few seconds will go by then the furnace should activate. Once the furnace heats the room to the set temperature the furnace should shut off.


How does a 240 volt hot water heater thermostat test for normal operation?

As with any thermostat it is based on where the set point is on the temperature scale. On hot water tanks the thermostat opens the element circuit when the set point temperature is reached. For example the set point should be around 135 degrees F. When cold water enters the tank, the thermostat closes due to sensing a temperature lower than the set point is set at. When the water heats up to 135 degrees the thermostat open because the set point is reached.To test the thermostat shut the power off at the distribution panel for the hot water tank. To do this test the water in the tank should be up to temperature. Remove the wires from the thermostat that is to be tested. Make a diagram of how the wires were connected. Using a continuity tester (ohm meter works fine) place the leads across the terminals where the wires were connected. If there is no reading then the set point is satisfied and the circuit is open. Leaving the tester leads on the terminals, with a screw driver raise the set point to a higher value. The meter should now show continuity between the terminals. Turn the set point down and the terminal reading should open. If this is happening then that thermostat is operating fine. Reposition the thermostat to the original set point. If you are working on the top thermostat now do the same to the bottom thermostat to see if it is working also.See related link below.


What temperature thermostat should a 1995 Ford Explorer use in the winter?

Motorcraft . com lists ( Motorcraft RT1161 ) a 190 degree Fahrenheit thermostat for the 1995 Ford Explorer to be used year round