0
What else can I help you with?
Can you use the upper receiver on the hk417 with the lower receiver of the hk416 rifle?
No. The HK417 is chambered for the much larger 7.62x51 cartridges, and the upper receiver will be too long to be fitted to a 5.56x45 HK416 lower.
Can I get a replacement rail for a bushmaster ar15 carbon 14 flat top upper receiver without the rear sight this rail has one removable screw and then the rail slides off the upper receiver?
yes
Major Component Groups of the M16 Rifle?
Upper Receiver: Bolt Carrier Group: Gas System Lower receiver: Trigger Group
Where is the Volvo v40 key fob receiver loacated?
in the upper control module
Can AR-15 convert to a higher caliber?
Yes, if you replace the upper receiver.
How do you remove an ar 15 buffer tube?
remove the forward grip, pull the set pin out of the front site a frame and pull the tube toward the upper receiver until it clears the a frame, then pull it out of the upper receiver.
Will a 7.62 x 39 upper function on a 5.56 lower receiver?
yes, no problem
What is a Mid Length Upper Receiver ar15?
A mid-length upper receiver uses a mid-length gas system. The barrel length is between 14.5 inches and 18 inches, and the handguards are slightly longer to accommodate the gas system.
Will a ar-15 pistol upper receiver fit on a standard ar15 lower receiver?
Yes, it will, but then it would be in an SBR (short-barreled rifle) configuration, and would be a violation of federal law if the lower receiver is unregistered.
Do you need a background check to buy a upper receiver?
In the United States, purchasing an upper receiver for an AR-15 or similar firearm does not typically require a background check, as the upper receiver is considered a non-firearm component. However, it is important to note that laws can vary by state, and some states may have additional regulations that could affect the purchase. Always check local laws and regulations to ensure compliance before making a purchase.
What are the M4A1 Carbine Disassembly steps?
To disassemble the M4A1 Carbine, first ensure the weapon is unloaded by removing the magazine and visually inspecting the chamber. Next, pull the charging handle to the rear and ensure the bolt is locked to the rear. Then, push the takedown pins located on the lower receiver to the left, allowing the upper receiver to be separated from the lower receiver. Finally, remove the bolt carrier group and charging handle from the upper receiver for further disassembly if needed.
Where is the serial number on a marlin original golden 39m?
Look at the lower forward receiver,the lower tang,or upper tang.
