answersLogoWhite

0

Placing bottle a few inches from the wound, pull back and simultaneously squeeze and jerk the bottle towards the wound. This causes the dust to spray out of the bottles nozzle, keep this motion up until the wound is generously covered. - Note wonder dust is only for miner wounds, and should be applied after the wound is cleaned.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you properly clean shoes?

If it's leather shoes, you need to brush the dust off them and apply shoe polish on it.


Short for angel dust?

Angel dust is PCP. A drug used as a horse tranquilizer. It is known to cause violence in some people.


Why would disc brake pads wear different?

due to presence of dust & small dust particles in the gap.Also if the disc is not aligned properly.


What is volcano dust?

The "dust" from a volcano, more properly called ash, consists of tiny pieces of rock and glass blasted out when a volcano erupts explosively.


How does a horses bath?

If the horse is a pet you have to do it yourself, they just roll in the dust to clean themselves. x


How should I properly apply steel wool between coats of polyurethane for a smooth finish?

To properly apply steel wool between coats of polyurethane for a smooth finish, lightly sand the surface with fine steel wool in the direction of the wood grain. This will help remove any imperfections and create a smooth surface for the next coat of polyurethane. Be sure to wipe away any dust before applying the next coat of polyurethane for best results.


What season should a horse were a blanket?

You can put a heavy blanket on a horse in the winter to help keep the horse warm and keep dirt and mud off. Also you can keep a very lightweight blanket on the horse in the summer to keep dirt,dust,and mostly flies off your horse.


Are magnetic dust sweepers harmful to computer equipment?

Magnetic dust sweepers are typically not harmful to computer equipment. You should not apply one directly to the equipment however.


How do you properly apply plaster over drywall to achieve a smooth and seamless finish?

To properly apply plaster over drywall for a smooth finish, first, prepare the surface by sanding any rough areas and cleaning off dust. Next, mix the plaster according to the manufacturer's instructions and apply it evenly using a trowel. Smooth out the plaster with a damp sponge or trowel, working in small sections. Allow the plaster to dry completely before sanding it lightly and applying a second coat if needed. Sand again after the final coat for a seamless finish.


How should I properly apply mineral spirits on wood after sanding to achieve the best results?

After sanding the wood, apply mineral spirits using a clean cloth in a well-ventilated area. Wipe the wood in the direction of the grain to remove any dust and debris. Allow the mineral spirits to dry completely before applying any finish for the best results.


How can I properly apply varnish to a table top for a durable and attractive finish?

To properly apply varnish to a table top for a durable and attractive finish, follow these steps: Sand the table top to create a smooth surface. Clean the surface to remove any dust or debris. Apply a coat of varnish using a brush or cloth, following the wood grain. Allow the varnish to dry completely before applying additional coats. Sand lightly between coats for a smooth finish. Apply multiple coats of varnish for added durability. Allow the final coat to cure for the recommended time before using the table.


Can you use calcium chloride flakes on dirt road to keep the dust down?

Yes, calcium chloride flakes can be used on dirt roads to help control dust. When applied, they absorb moisture from the air, which helps to keep the road surface damp and reduces dust creation. This method is often more effective than water alone, as it can provide longer-lasting results. However, it’s important to apply the flakes properly and in the right quantities to ensure effectiveness.