Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specific cause/defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors. And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
NO. ONLY 1996 TO A 2000 WILL WORK. THERE IS STILL SMALL CHANGES TO DO BETWEEN THOSE YEARS. HOPE THIS HELPS.
bolt size on 2000 dodge stratus alternator
A 2000 Dodge Stratus has four engine mounts.
2000 dodge stratus is electronicly timed you can not time it.
yes
A Dodge Stratus does not have a reset switch.
Yes
No
How do I disconnect the horn on my 2000 Dodge Stratus? Everytime I turn the wheel, as of last evening, it goes off!
No, they are quite a bit different.
The 2.5 liter V6 engine in a 2000 Dodge stratus has a timing BELT
The diagram for a 2000 Stratus water pump and cooling system is in the Dodge Stratus service manual. The manual can be purchased through most auto parts.